Electrolux Range / Cooktop / Oven Parts

This electronic control board manages a refrigerator's core functions and user interface, restoring proper cycle control and responsive panel operation when the original board fails. What it does:

• Regulates compressor and defrost cycles to maintain correct cooling patterns
• Processes user inputs from the control panel and display
• Controls timed events like defrost and fan operation
• Faulty boards can cause unresponsive controls, incorrect temperatures, or erratic cycling

• Disconnect power before removing or installing the board to avoid shock or damage
• Handle the board by the edges and avoid static discharge; use an anti-static wrist strap if available
• Verify the board's part number against your unit before installation—some repairs require matching sub-models

This support is a replacement mounting bracket that secures internal components and restores proper alignment and stability. Use it when a broken or missing support causes rattling, misalignment, or loose parts. What it does:

• Provides structural support for internal assembly parts to prevent movement or vibration
• Restores proper alignment so doors, drawers, or moving components operate smoothly
• Stops noises and rubbing caused by a cracked or missing bracket
• Helps maintain safe, reliable operation by keeping parts secured

• High-level replacement: remove access panels and fasteners to reach the damaged bracket; mirror steps to reinstall
• Use the same screw locations and hardware as the original; retain mounting screws when removing the old part
• Disconnect power before accessing internal components to reduce shock risk

This adhesive seal tape is a replacement sealing strip used to restore a tight seal on appliance doors and panels, helping reduce air leaks and improve temperature control. It's a simple repair for worn or damaged seal edges. What it does:

• Provides a flexible, adhesive sealing surface to close gaps between door/panel and cabinet
• Helps reduce air or moisture leakage that can cause temperature loss or inefficient operation
• Restores worn or deteriorated sealing surfaces without replacing the entire gasket
• Compatible with applications where a narrow adhesive sealing strip is required

• Clean and dry the mounting surface thoroughly before applying for best adhesion
• Measure and trim the tape to fit; press firmly along the full length to ensure contact
• Allow adhesive to set per ambient conditions before closing the door or returning to service

This is a 10-24 x 1/2 inch machine screw used to secure temperature probes, thermistor brackets, shields and drawer/box components. It provides a simple, reliable fastener for small appliance assemblies. What it does:

• Secures probe or thermistor brackets to the appliance chassis or housing
• Holds shielding or small drawer/box parts in place to prevent movement or rattling
• Helps maintain correct sensor positioning so temperature readings stay stable
• Common replacement when a stripped, corroded, or missing screw causes loose parts or vibration

• One 10-24 x 1/2 in. screw

• Use the matching 10-24 threaded hole; avoid over-tightening to prevent stripping or cracking nearby plastic
• If replacing a corroded screw, inspect mating threads and components for damage before reuse
• Turn off and unplug the appliance or disconnect power before accessing internal components

This small plastic clip secures the dishwasher drain hose to the pump assembly or discharge fitting, keeping the hose in place and helping prevent leaks or disconnection during operation. What it does:

• Holds the drain hose firmly to the pump or outlet fitting to maintain a watertight connection
• Prevents the hose from slipping free during drain cycles
• Helps stop water leaks and washing chamber flooding caused by a loose hose
• Useful when replacing a cracked or broken retaining clip

• One drain hose retaining clip

• Disconnect power and water supply before accessing the dishwasher lower access area
• Remove the access panel or kickplate to reach the drain hose and pump connection
• Use pliers or a flat tool to remove the old clip and snap the new clip over the hose/fitting until fully seated
• After installation, run a short drain cycle and inspect for leaks; re-secure if necessary