Electrolux Range / Cooktop / Oven Parts

Range not heating or display blank? This electronic control board manages oven functions and temperature. Moderate difficulty repair requiring basic tools.

Foam tape gasket seals cooktop components and prevents heat loss. Replace when worn, compressed, or damaged to maintain proper insulation. Confirm fit with your model number.

Mounting screw for microwave installation and assembly. Replaces lost, stripped, or damaged screws that secure panels, brackets, or components.

Fix a microwave that won't heat or start with this thermal cutout fuse. This safety component prevents overheating. Takes 30-45 minutes to install.

This thermal cut-out is a temperature-sensing safety device that helps protect the refrigerator's defrost/heater circuit by opening the circuit when temperatures exceed safe levels. It prevents overheating and helps maintain normal defrost cycles. What it does:

• Senses temperature in the defrost/heater area and opens the circuit to stop heating if temperatures get too high
• Prevents overheating of defrost heater or related components
• Can cause defrost failure symptoms when faulty, such as excessive frost buildup or poor cooling
• May also contribute to long run-times or irregular defrost cycles when not operating correctly

• Disconnect power to the appliance before servicing to avoid electrical shock
• Handle the part and wiring gently; ensure correct orientation and secure connections per service manual
• Use the exact replacement part number for compatibility

Microwave not heating? This high voltage transformer powers the magnetron to generate heat. Critical component requiring careful installation.

Replacement front cabinet trim frame for microwaves. Restores finished look when original is cracked, warped, or broken. Secures control area alignment.

Replace a damaged or frayed range wire harness. This internal wiring component connects electrical parts inside your oven. Order now if yours is broken or burnt.

Spacer bumper for electric ranges and wall ovens. Installs between panels or components to provide proper spacing. Replace if cracked or missing.

Wiring harness assembly that routes power and signals between your wall oven's control and components. Replace when harness is damaged or corroded.

Microwave not heating? The high voltage diode converts AC to DC for the magnetron. Common failure part when food stays cold. Moderate skill repair.

This snap bushing is a push-in panel grommet that protects and secures wiring where harnesses pass through metal or plastic panels. It prevents chafing and helps keep wire routing neat for safer operation. What it does:

• Cushions and shields wires from sharp panel edges to reduce abrasion and shorts
• Secures wiring harnesses in place to prevent unwanted movement or snagging
• Provides a finished, vibration-resistant pass-through for electrical leads
• Commonly replaced when the original bushing is cracked, broken, or missing

• One snap bushing

• Disconnect power before servicing electrical components
• Press-fit into the panel hole until the bushing snaps into place; confirm a secure fit
• Replace if brittle, torn, or deformed; do not use a damaged bushing
• Use pliers for removal if needed; avoid forcing or enlarging the hole