Electrolux Range / Cooktop / Oven Parts

Foam tape gasket seals cooktop components and prevents heat loss. Replace when worn, compressed, or damaged to maintain proper insulation. Confirm fit with your model number.

Mounting screw for microwave installation and assembly. Replaces lost, stripped, or damaged screws that secure panels, brackets, or components.

This is a thermal cut-out safety device that shuts off the microwave when internal temperatures exceed safe operating limits. It functions as a protective thermostat to prevent overheating and potential damage to the appliance. Replace this part if the microwave shuts off unexpectedly during use, fails to power on, or if the unit is overheating.

Replace your microwave's light socket if bulbs fail to illuminate despite having power. Restores interior or under-cabinet lighting. Verify fit by model.

Microwave not heating? This high voltage transformer powers the magnetron to generate heat. Critical component requiring careful installation.

This is a door hinge for a microwave oven that allows the door to pivot open and closed. It supports the weight of the door and ensures it seals properly against the frame when shut. Replace this hinge if the microwave door sags, does not close evenly, or if the hinge is visibly bent or broken.

Replacement front cabinet trim frame for microwaves. Restores finished look when original is cracked, warped, or broken. Secures control area alignment.

Mounting screw for microwave installation. Secures microwave to cabinet or wall bracket. Replace if missing, stripped, or damaged during installation.

Replace a damaged or frayed range wire harness. This internal wiring component connects electrical parts inside your oven. Order now if yours is broken or burnt.

Spacer bumper for electric ranges and wall ovens. Installs between panels or components to provide proper spacing. Replace if cracked or missing.

Wiring harness assembly that routes power and signals between your wall oven's control and components. Replace when harness is damaged or corroded.

Microwave not heating? The high voltage diode converts AC to DC for the magnetron. Common failure part when food stays cold. Moderate skill repair.

This snap bushing is a push-in panel grommet that protects and secures wiring where harnesses pass through metal or plastic panels. It prevents chafing and helps keep wire routing neat for safer operation. What it does:

• Cushions and shields wires from sharp panel edges to reduce abrasion and shorts
• Secures wiring harnesses in place to prevent unwanted movement or snagging
• Provides a finished, vibration-resistant pass-through for electrical leads
• Commonly replaced when the original bushing is cracked, broken, or missing

• One snap bushing

• Disconnect power before servicing electrical components
• Press-fit into the panel hole until the bushing snaps into place; confirm a secure fit
• Replace if brittle, torn, or deformed; do not use a damaged bushing
• Use pliers for removal if needed; avoid forcing or enlarging the hole