Electrolux Range / Cooktop / Oven Parts

It was a very simple fix - removed two screws (one from each end of the handle). I then held the new handle in place and replaced the two screws. Read more

Replace element. Read more

Bought new leveling leg. Took longer to lay the appliance on the side and pick back up, than to install leg. Read more

Installed a new ignitor/orifice assembly. Read more

Replaced burner with new. Did the trick. Works like new. Read more

Turned off the power. Pulled out the stove. Removed back of upper part of stove. Removed old control board. Took photos with phone to make sure I got wires back on correctly. Only 1 wire was difficult to remove and required gentle rocking with pliers. Put the overlay on the new board. Placed all the clips and wires back on the new board. Turned on power to test. Tested ok. Turned power off and resecured the board and back on the stove. Repositioned the stove. Turned power back on. I... Read more

Looked up the part number and ordered it through AppliancePartsPROS. They had the lowest price and the part came quickly. Read more

We took the old ones off and put the new ones on..it was easy to do ..I want to say that the girl (I think her name was Heidi) she was a big help ,she made sure that I had the right parts,I ask her to show me the picture to make sure that they look like the part ..She was a really big help. I did a survey when I ordered the parts to..Thank you for your help and the parts Anna P Read more

I purchased 2 new light rocker switches, Because the heating element rocker switch was unavailable. First I removed the power source for safety. Then I simply pulled each switch out individually with a flathead screwdriver for leverage. I simply unplugged the wires from the old rocker switch, discarded the old rocker, plugged the wires into the new rocker switch, and pushed the new switch appropriately back into the control panel. I used the same steps for both rocker switches. Once... Read more

Removed the element "easy just four screws" unplugged two connecting wires, removed element. Did a "continuity test" on element, it failed, so I ordered a new one and installed it. It works great now. Read more

• Door stuck closed

Turn off breaker, remove all screws { 4 on mine } inside oven door holding oven and microwave to kitchen cabinet and slide oven assembly out of cabinet {on to a temporary shelf of {4} 5 gallon buckets/plywood/bricks/shims that I made on the floor atop a scrap of carpet} just enough to access the side and rear screws of microwave's protective metal housing, then remove a total of 16 screws { there were 2 screws just inside top of "opened" microwave door that were holding top flat silver metal... Read more

Easy just pull clip and put back Read more

Pulled off the old one, pushed on the new one. Read more

Found the parts I needed ordered them from your site Received them and installed in a few minuets and was done Read more