Electrolux Range Switch

If your cooktop burner won't heat, stays on high, or won't turn off, a faulty burner control switch is often the cause. DIY repair in 15-30 minutes.

This is a door-activated switch that detects whether the oven door is open or closed. It controls functions such as the oven light or signals the control board about door position. Replace this switch if the oven light stays on or off regardless of door position, or if the oven does not operate correctly due to a faulty door signal.

This switch assembly restores electrical on/off control for a specific appliance function. Replace a worn or failed switch to stop intermittent operation and return reliable control to the affected circuit. What it does:

• Provides the electrical on/off or function control for the appliance circuit.
• Replaces a failed switch that can cause intermittent operation or unresponsive controls.
• Helps resolve symptoms such as a function that won't start, no response from the control, or erratic switching.
• Connects to the existing wiring harness and mates with the original mounting points.

• Disconnect power to the appliance before beginning any work.
• Remove the appropriate access panel to reach the switch; note wire and terminal locations before disconnecting.
• Unplug the wiring harness or carefully detach terminals, swap the switch assembly, then reconnect securely.
• Restore power and verify the replaced switch operates the function correctly.

Range burners won't light or clicking but not igniting? This igniter switch controls spark ignition for reliable burner lighting. Moderate DIY repair.

This rack sensor switch assembly detects rack position and completes the electrical connection needed for proper operation of the appliance's rack-related functions. Replaces a worn or damaged switch to restore reliable rack sensing. What it does:

• Acts as the rack-position sensor/switch that signals the control when the rack is in place
• Restores intermittent or failed rack-detection that can interrupt related functions
• Helps prevent control errors or unexpected behavior caused by a faulty switch
• Commonly replaced when the switch is cracked, corroded, or unresponsive

• One rack sensor switch assembly

• Disconnect power to the appliance before servicing to avoid shock hazard
• Handle with care to avoid damaging the connector or surrounding components
• Basic hand tools may be required; access instructions available

Fix range display issues, unresponsive controls, or error codes with this control board assembly. Common repair for ranges that won't start or heat properly.

Replace a range infinite switch when a burner won't heat, overheats, or stays on continuously. Controls surface element temperature settings.

This genuine wiring harness connects and routes power and signals between refrigerator components to restore reliable electrical connections and component control. It replaces damaged or worn wiring to stop intermittent faults and loss of function. What it does:

• Carries power and signal between fridge modules and components for normal operation
• Replaces frayed, burned, or broken wires and damaged connector ends
• Helps stop intermittent component failures, no-power conditions, and electrical arcing
• Restores secure plug-and-play connections for affected circuits

• One complete harness assembly as shown

• Disconnect power to the appliance before starting any work
• Follow OEM routing and secure with existing clips; avoid pinching or sharp edges
• Match connector shapes and colors; do not force connectors to fit

This switch controls the oven or cooktop light, allowing you to turn illumination on and off as needed. It mounts in the control panel and completes the electrical circuit to the light fixture. Replace this switch if the oven light no longer responds when the button is pressed or if the switch feels loose or stuck.