Estate Range / Cooktop / Oven Parts

Color: Biscuit. Left hand side. For right hand use 98008275. For white use 98005336. For black use 98004632.

Color: Biscuit. Right hand side. For left hand use 98008274. For black use 98004633. For white use 98005337.

This rocker switch replaces a worn or broken control rocker to restore reliable on/off operation and user control. The biscuit finish matches appliance control panels for a clean, factory appearance. What it does:

• Acts as the user-operated on/off actuator for the appliance control circuit.
• Restores consistent activation when the original rocker is cracked, stuck, or unresponsive.
• Can eliminate intermittent operation or failure-to-start symptoms caused by a damaged actuator.
• Provides a color-matched replacement to maintain the look of the control panel.

• Disconnect power to the appliance before beginning any repair to avoid shock.
• Access typically requires removing the control panel or console; keep track of screws and fasteners.
• Avoid touching live terminals; reconnect power only after confirming secure, correct wiring.

This cover guide is a small trim piece that protects and guides nearby components, helping keep panels and moving parts aligned for smoother operation. It replaces a worn or damaged guide to reduce rubbing and improve fit. What it does:

• Covers and protects the guide channel or track from wear and debris
• Helps maintain proper alignment of adjacent panels or moving parts
• Reduces noise or rubbing caused by a damaged guide
• Restores secure fit where the original guide is cracked, warped, or missing

• Disconnect power to the appliance before starting any repair.
• Typically installs with snap tabs or a few screws; basic hand tools may be required.
• Align tabs or mounting points carefully to avoid breaking plastic clips.
• If clips are damaged, replace them before reassembly to ensure a secure fit.

A direct-replacement door counterbalance spring that helps your appliance door open and close smoothly and stay properly aligned. Restores proper door tension to prevent sagging, uneven closing, and decreased seal contact. What it does

• Counterbalances door weight so the door opens and closes with correct tension
• Helps doors remain level and prevents sagging or dropping during use
• Reduces strain on hinges and latch components for more reliable closing
• Resolves symptoms like a door that falls shut, won't stay open, or feels heavy/uneven when moved

• One door spring

• Disconnect power (and water if applicable) and follow all safety procedures before starting
• Use hand protection and eye protection; springs can release with force
• Inspect hinge and mounting hardware for wear; replace damaged components as needed
• Refer to the appliance's service manual or OEM diagram for correct orientation and routing during installation

Color: Biscuit

This backguard is the replacement rear console panel that restores the look and protective cover behind the range control area. It helps protect wiring and controls while keeping the appliance appearance neat and finished. What it does:

• Replaces a cracked, dented, rusted, or missing rear console panel
• Protects control wiring and components from spills and debris
• Restores a clean, factory appearance to the back of the range
• Helps prevent drafts behind the control area and keeps controls accessible

• Disconnect power to the appliance before starting any work.
• Range may need to be pulled away from the wall to access mounting screws.
• Use appropriate tools; some models require removing trim or control housing to install.
• Parts and edges may be sharp—wear gloves and handle carefully.

Color: Biscuit. For white use WP98010042. For black use WP98010043