This is a replacement screw used to secure panels, trim, or small components on compatible Whirlpool appliances. Installing the correct fastener restores proper fit and helps stop rattles or loose trim. What it does:
- Secures trim, panels, or control components to prevent movement and rattling
- Replaces missing or damaged hardware that can cause gaps or loose parts
- Helps maintain proper alignment of panels and movement-free operation
- Used wherever a factory screw of this size and head style is specified
What's included: One screw Install notes:
- Always disconnect power (and water, if applicable) before servicing the appliance
- Use the correct screwdriver or driver bit to avoid stripping the head
- Install by hand until threads engage, then tighten snugly—do not overtighten
- Keep removed hardware organized before final reassembly
Do-It-Yourself Stories from Customers like You
Igniter was lighting but gas wouldn't ignite Timothy G. • Lumberton , NJ • December 21, 2014
Igniter was lighting but gas wouldn't ignite. I would see the igniter light up and smell some gas, but the flame would not light. After looking at some websites, it seemed that the igniter was weak and wouldn't cause ignition, even though it was glowing. Since the part numbers were the same, I switched the broiler and the oven igniters. The oven began working and the broiler wouldn't light. So, I ordered the new part (igniter) and replaced the broken one.
I had to pull the oven away from...
Read more