Estate Range Panel Parts

Best Seller

Genuine Whirlpool part

Estate Burner Box (Electric)

By: Whirlpool

Part Number: W11699791

This burner box is the under-top housing for an electric cooktop or range. It supports the surface heating elements and mounting hardware, restoring proper element alignment, stability, and safe operation when the original housing is bent, corroded, or damaged.

Supports and positions the surface heating elements beneath the cooktop
Provides mounting points for element brackets and component supports
Helps keep elements level and secure for consistent heating performance
Common symptoms: loose or sagging elements, rattling/vibration from the cooktop area, visible warping or corrosion, difficulty fastening element hardware

What's included: 1 burner box housing Install notes:

Disconnect power at the breaker before servicing
Lift/remove the cooktop to access the burner box; sheet-metal edges can be sharp—wear cut-resistant gloves
Transfer elements, brackets, and wiring to the new box in their original locations; take photos for reference
Ensure wiring is routed clear of hot surfaces and all fasteners are secure before reassembly and testing

Do-It-Yourself Stories from Customers like You There was a hole rusted in the box burner Charles H. • Avon Park , FL • May 08, 2017

I first DISCONNECTED POWER FROM THE RANGE using the breaker. I then pulled the range out from the wall to give myself plenty of working room. I lifted the range top up as when you clean under the burners. I then moved the ends of the bottom of the slide rods that lock the range top open back where they came loose from the top of the range. This allows you to fold it higher and have complete access to the top of the range. I then took out all the Phillips head screws that hold down the sheet... Read more

$123.95

Compare At:: $147.50
You Save:: $23.55

IN STOCK

Ships Today Guaranteed

Add to Cart

Best Seller

Genuine Whirlpool part

Estate Oven Bottom Panel

4.9 (17)

By: Whirlpool

Part Number: WP3195097

This panel forms the floor of the oven, sitting above the bake element or burner to shield it from spills and provide a smooth, stable surface. Replace a warped or damaged panel to help maintain proper heating and easier cleanup. What it does:

Forms the oven floor above the bake element or burner
Shields the heat source from drips and debris to help prevent scorching and odors
Supports designed airflow and heat distribution in the cavity
Common replacement signs: warped or dented panel, rust or chipped finish, smoke/odors from spills beneath the panel, or uneven baking results

What's included:

1 oven bottom panel

Install notes:

Disconnect power (and shut off gas supply for gas ranges) before servicing; allow the oven to cool completely
Remove oven racks; release front fasteners or clips and lift the old panel out of the rear tabs (method varies by model)
Seat the new panel into rear tabs, align the front edge, and secure as originally installed
Verify the panel sits flat and clear of the bake element or burner before reassembling

Do-It-Yourself Stories from Customers like You Oven burner occasionally failed to light usually in the middle of roasting a turkey or chicken oven then "locked down " Ulrich O. • Millburn , NJ • January 05, 2015

The problem is a finicky ignition system, Direct Spark Ignition. Apparently Whirlpool redesigned the igniter/burner assembly slightly to make it more reliable. The repair is very easy. Turn off power, but you don't need to turn off gas. Remove oven bottom and flame spreader, then remove burner/igniter assembly, one screw at front, one at back. Lift out burner assembly carefully to avoid stretching wire. Pull electric connector from pin on burner/igniter assembly. Vacuum to clean oven. ... Read more

$97.95