Parts for Ge ZDIS15CSSP: 02 - Evaporator, Ice Cutter Grid & Water Parts

This genuine replacement part is a water valve for refrigerator ice makers. The water valve supplies water to the ice maker to fill the water reservoir. If the icemaker is no longer operating properly and no longer dispensing ice, it might mean that the water valve needs to be replaced. Thankfully, replacing this part is an easy repair. To begin, make sure all the power is turned off to the appliance. Open the freezer door where the water dispenser is located. Remove the inner panel of the door by unfastening the screws that secure it. Once the panel has been removed locate the old water valve and release it from its mounting brackets. Once removed, replace with the new water valve. Reinstall the door panel and restore power to the refrigerator. This OEM part is compatible with General Electric, Hotpoint, and RCA brand refrigerators.

This pushnut fastener secures shafts, studs, and small components by snapping into place for a reliable hold without threads. It's a simple replacement part that restores proper retention for panels, knobs, or internal linkages. What it does:

• Grips and locks onto a shaft or stud to prevent axial movement
• Holds small panels, trim, or linkages in place where a threaded fastener isn't used
• Helps stop rattles and intermittent disengagement caused by a worn or missing retainer
• Works where a quick, tool-friendly installation is preferred

• One pushnut fastener (quantity: 1)

• Push onto a clean, undamaged shaft or stud until fully seated; do not hammer on delicate components
• Inspect mating shaft/stud for burrs or damage—replace if necessary to ensure secure fit
• Wear eye protection; small parts can snap off or eject during installation
• If removal is required, use a thin pry tool or pick to avoid distorting the retainer

This cover grid is a factory-design trim panel that protects and finishes the refrigerator interior where airflow or components pass through. It restores proper fit and appearance and helps keep internal components covered. What it does:

• Covers and protects internal openings to prevent debris from reaching components
• Restores finished appearance to the refrigerator interior after damage or removal
• Helps maintain proper airflow routing by keeping openings trimmed and aligned
• Reduces rattles or vibration caused by a loose or broken trim piece

• One cover grid trim panel

• Install with manufacturer-recommended fasteners; verify alignment before tightening
• Power off and unplug the appliance before accessing internal areas
• Handle gently to avoid snapping plastic tabs; replace any broken clips
• Replace any missing or damaged trim or mounting hardware for secure fit