Parts for Dacor ER48DSCHLP: Exterior Parts

This right side panel assembly restores the refrigerator's exterior finish and protects internal components from dust and damage. It replaces a dented, cracked or missing side panel for a clean, secure cabinet edge. What it does:

• Covers and protects internal insulation, wiring, and components on the appliance's right side
• Restores exterior appearance after impact, corrosion, or panel loss
• Helps maintain proper cabinet enclosure to reduce drafts and moisture intrusion
• Supports attachment points for trim and adjacent panels

• Disconnect power and empty/secure interior shelves before starting work
• Remove mounting screws and any trim pieces to access the existing panel
• Use caution with sharp sheet-metal edges; wear gloves and eye protection
• Replacement typically requires basic hand tools; consult model-specific guide

This left-side service panel assembly replaces a damaged or missing side cabinet panel to restore the appliance's exterior protection and appearance. It provides a secure mounting surface for internal components and helps keep wiring and insulation covered. What it does:

• Replaces the left side outer panel to protect internal parts from dust, debris and accidental contact
• Restores the appliance's exterior fit-and-finish after impact or corrosion damage
• Provides a mounting surface for brackets and components located along the cabinet side
• Helps maintain proper airflow paths by keeping panels aligned and sealed

• Disconnect power before starting any repair to avoid shock or injury
• Handle panel edges carefully; use gloves to prevent cuts and protect finish
• Installation typically requires removing adjacent panels and fastening with the OEM screws or clips
• Verify alignment and secure all fasteners; check that doors or panels open and close freely after installation

Rubber bumper cushions oven door and components. Replace if cracked, worn, or missing to restore quiet operation and prevent metal-on-metal contact.

This is a metal anti-tip bracket that secures a freestanding range to the floor or wall to prevent the unit from tipping forward. It is a critical safety component, especially when heavy items are placed on an open oven door. Replace this bracket if it is missing, bent, or damaged during installation or kitchen remodeling.