Parts for Kitchenaid KFIS20XVMS7: 09 - Freezer Door Parts

Replace your refrigerator water filter every 6 months to ensure clean, fresh-tasting water and ice. Easy twist-on installation. Verify fit with your model.

Black handle for refrigerator doors and drawers. Replace a cracked, loose, or missing handle to restore a secure grip and refresh your appliance's look.

Mounting bracket for refrigerators. Secures internal components in place. Replace if cracked, bent, or broken to restore proper structural support.

Left-side slide bracket that secures and guides drawer assemblies in refrigerators. Replaces worn, cracked, or broken brackets to restore alignment.

Seals freezer door to prevent warm air infiltration and ice buildup. Replace if you feel cold air leaking or see frost accumulation. Confirm fit with model.

Mounting bracket for bottom-mount refrigerators. Secures internal components in place. Replace if bracket is cracked, broken, or missing hardware.

Replacement freezer drawer bin for bottom-mount refrigerators. Restores storage organization when original basket is cracked, broken, or missing.

Threaded anchor that secures refrigerator door handles to the door panel. Replace if cracked, stripped, or missing to properly mount your handle hardware.

Secures internal components to the refrigerator chassis. Replace this mounting bracket if cracked, bent, or broken to restore stable support alignment.

This is a slide rail glide that supports the freezer drawer and allows it to open and close smoothly. It mounts inside the freezer compartment and helps keep the drawer properly aligned on its track. Replace this glide if the freezer drawer sticks, wobbles, does not slide evenly, or if the original glide is cracked or worn.

Guides the upper freezer basket smoothly in and out. Replace when drawer sticks, binds, or scrapes due to cracks or damage. Verify fit with your model number.

This replacement screw secures panels, brackets, and components inside appliances. Replacing a missing or stripped fastener restores a snug, rattle-free fit using the correct #8-18 thread and 5/8-inch length.

• Fastens covers, trims, brackets, and internal parts to the cabinet/frame
• Used wherever a #8-18 x 5/8 screw is specified
• Replace if the original is missing, corroded, stripped, or will not tighten
• Symptoms: loose or rattling panels, gaps, or hardware that backs out

• Disconnect power; shut off gas/water before servicing
• Match thread and length; start by hand to avoid cross-threading
• Use the correct driver bit and tighten snugly—do not overtighten
• Inspect and replace damaged clips or tabs before securing