Frigidaire Dryer Door, Door Glass & Parts

The Outer Door Panel is an OEM part for Frigidaire washing machines. This panel acts as the exterior surface of the washer door, providing both a protective barrier and an aesthetically pleasing finish. It is designed to fit seamlessly with the washing machine, maintaining its sleek look and ensuring the door operates smoothly.

You should replace this outer door panel if it becomes damaged or worn out. Causes of a bad outer door panel can include impacts that cause dents or scratches, exposure to moisture leading to rust or corrosion, and regular wear and tear that affects its appearance and function.

Symptoms of a bad outer door panel include:

• Visible dents or scratches on the panel
• Rust or corrosion spots
• The panel not aligning correctly with the door frame
• Issues with the door closing or sealing properly

This OEM replacement is also compatible with Electrolux, Gibson, Kelvinator, and Kenmore models.

Plastic door cover

This replacement door glass forms the clear window in the door of select front-load units, restoring safe visibility and proper door fit. Replace a cracked, chipped, or shattered pane to prevent leaks and ensure the door seals and latches correctly. What it does

• Creates the viewing window in the door and mates to the door gasket/boot
• Helps maintain a proper seal to contain wash action
• Restores safe operation when the original glass is damaged
• Common symptoms: visible cracks or shattering, water leaking from the door area, door not closing flush, rattling glass

• 1 door glass pane

• Disconnect power and turn off water supply before service
• Wear cut-resistant gloves and eye protection; handle glass carefully
• Remove the door, set it on a padded surface, and transfer trim/gasket as designed
• Tighten fasteners evenly and check gasket alignment to prevent leaks

Replace a cracked or cloudy door window with this outer lens. It forms the transparent exterior panel of the door, protecting the inner window and restoring a clean look and clear view into the drum during cycles.

• Forms the exterior, see-through panel of the door window
• Shields the inner window and helps the door close evenly against its trim
• Replace if the outer window is cracked, chipped, warped, loose, or discolored/cloudy
• Damage may cause poor visibility or sharp edges around the door opening

• Disconnect power before servicing the appliance
• Remove the door and place it on a padded surface
• Separate inner/outer door panels, note screw locations, and lift out the old lens
• Clean mating surfaces; set the new lens in place and reassemble without over-tightening screws

This control panel is the exterior front panel that houses the oven/range controls and provides a finished look while protecting the underlying electronics. It restores a secure mounting surface and normal control access. What it does:

• Provides the user interface area and mounting surface for control buttons, knobs, or touch controls
• Protects internal control electronics from spills, heat, and debris
• Restores a flush, finished appearance when the original panel is cracked, dented, or missing
• Resolves issues where buttons or switches sit unevenly or are difficult to operate due to damaged trim

• Disconnect power to the appliance before starting any repair to avoid electrical shock
• Remove adjacent trim and mounting screws to access and replace the panel; handle carefully to avoid scratching or bending
• Keep all original fasteners; replace only parts explicitly required
• If controls or electronic modules are mounted to the panel, verify attachment and wiring connections before restoring power