James C Fairlawn , VA March 08, 2019 Control module going out Well, after searching for a model number on the range, had to pull the existing module for the part number. Ordered and was shocked to see it arrive the very next day (no, didn't pay for next day). Went back together a lot quicker then me taking apart! Read More... 3 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Pliers, Screwdrivers
Mark F Gainesville , FL January 10, 2019 The control panel had become detached from the range, because the plastic where the screws are inserted had broken in all 4 corners. Pulled the range out from the wall so I could get behind it. Unplugged it and removed the back plate from the range. Unplugged the two connections on the old panel to remove it. Adhered the overlay to the front of the new panel. Plugged it back in and attached it to the range with the 4 screws—careful not to tighten them too tight to avoid cracking the plastic. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Nut Drivers, Screwdrivers
Daniel F St Petersburg , FL November 25, 2017 Oven didn't work. Replaced the circuit board. board was delivered 3 business days after placing order, Installation took less than 15 minutes. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Nut Drivers, Screwdrivers
Dustin F Fort Loramie , OH January 02, 2018 The control panel burnt up Ordered these parts. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Nut Drivers
Gary H Batavia , NY March 08, 2022 Appliance: Kenmore Gas Range 79078572405 The oven display quit. I purchased a new display/control I also decided to purchase a new display "cover". I strongly suggest anyone buy that, as that cover is stuck on and would probably be difficult to remove and use over the new control. An easy job. The worst part was cleaning up the mess under the stove. Read More... Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Nut Drivers