Frigidaire Range Hood Parts

Exterior cover that finishes and protects your range hood's vertical duct area. Replaces cracked, damaged, or missing chimney covers for a clean look.

Install kit for range hoods. Includes mounting hardware and components needed for proper installation. Replace missing or damaged brackets and screws.

Extension kit for range hoods. Adapts ductwork height for proper installation. Replaces missing or damaged extension components during setup.

Fix a hood that won't power on or has no lights with this transformer. This essential electrical component converts voltage to power your range hood.

This is a blower wheel designed for use in a range vent hood. It attaches to the motor shaft and spins to pull air, smoke, and grease-laden vapors up through the hood and out the vent. Replace this part if your vent hood has weak airflow, makes rattling or scraping noises, or the fan vibrates excessively during operation.

This blower assembly circulates air through the appliance to support proper airflow and heat distribution, restoring normal operation and efficiency when the original blower is damaged or failing. It replaces worn or broken blower components to reduce noise and improve performance. What it does:

• Spins the blower wheel to move air through the unit for proper heating, cooling, or venting
• Restores airflow when reduced air movement causes longer cycles or poor performance
• Reduces unusual noise from a wobbling or damaged blower wheel/housing
• Helps prevent overheating caused by restricted or ineffective air circulation

• Disconnect power (and gas if applicable) before starting any repair
• Access typically requires removing exterior panels or the front panel; use basic hand tools
• Inspect and clean surrounding airflow paths and vents of lint or debris while replacing the blower

This is a charcoal filter designed for a range vent hood that recirculates air rather than venting it outside. The activated charcoal absorbs cooking odors, smoke, and grease particles from the air drawn through the hood. Replace this filter if you notice persistent cooking odors lingering in the kitchen or reduced effectiveness of your hood's ventilation.

This is a small washer used in range hood assemblies to secure components and reduce vibration. It helps maintain a tight, stable fit between mounted parts. Replace this washer if it is cracked, deformed, or missing, which can lead to loose fittings or rattling noises during hood operation.

Replace your broken or missing range hood control knob. This dial installs on the front panel to restore full operation of fan speed and light settings.

Rear support bracket with U-hook design for range hoods. Secures hood to wall during installation. Replace if bent, cracked, or missing hardware.

Fix no display, won't start, or intermittent power issues in your hood. This control board regulates voltage to restore reliable operation and startup.

Exterior metal shroud that covers and finishes your range hood's vertical duct section. Replace if cracked, dented, discolored, or missing.

Assorted mounting screws for securing hood panels and components. Replace stripped, missing, or damaged fasteners during repairs and reassembly.