Frigidaire Range Hood Parts

This recirculation kit lets a vented range hood or over-the-range microwave run in ductless mode, filtering and redirecting exhaust back into the kitchen when external venting isn't available. It provides a cleaner, odor-reduced recirculation option for non-duct installations. What it does:

• Converts a vented exhaust system to ductless recirculation so the appliance can operate without a roof or wall duct
• Houses/positions the filter media (charcoal/odor filter) to help reduce cooking smells when air is returned to the room
• Directs airflow inside the cabinet or appliance to maintain proper circulation
• Helps restore normal operation when external venting is blocked or impractical

• One recirculation conversion kit as shown

• Intended for use where external venting is not possible; follow appliance service manual for correct installation locations and orientation
• May require removal or relocation of existing duct parts and mounting hardware; verify that cabinet space and clearances meet the appliance instructions
• Use appropriate PPE and disconnect power before servicing
• Only install filters specified by the appliance manufacturer; replace filters per manufacturer guidelines

This canopy is the outer cover that hides and protects the range hood or over-the-range microwave vent area, restoring appearance and keeping internal components shielded from grease and debris. What it does:

• Replaces a cracked, dented, or missing canopy to restore the appliance's finished look
• Shields blower, control and wiring areas from grease, steam and food splatter
• Helps direct airflow from the hood/micro vent assembly
• Reduces visible gaps and prevents debris buildup on internal parts

• One replacement canopy

• Disconnect power to the appliance before starting work
• Remove mounting screws and support the hood/microwave assembly while replacing the canopy; two people may be required
• Handle edges carefully to avoid cuts; wear gloves if needed
• Reuse original fasteners unless replacement hardware is specified

This lamp holder assembly secures and powers the refrigerator interior light so you can see inside the compartment. It replaces a cracked, loose, or nonworking socket to restore reliable interior illumination. What it does

• Holds and provides the electrical connection for the interior light bulb.
• Replaces damaged or cracked socket housings that cause intermittent or no light.
• Secures the bulb in the correct position so the door switch and light operate properly.
• Helps eliminate flickering, loose bulb fit, or a socket that won't hold the bulb.

• 1 lamp holder assembly

• Disconnect power to the appliance before starting any repair (unplug or switch off breaker).
• Remove the bulb and cover/panel per your appliance instructions to access the socket.
• Disconnect wiring harness and replace the socket; ensure connections are secure and insulated.
• After installation, restore power and test the light operation.

This metal mounting bracket restores secure support for the appliance assembly it holds, helping stop loose panels and noisy operation. Replace a damaged or bent bracket to realign components and reduce vibration. What it does

• Secures and aligns a specific appliance component or panel to the cabinet/frame
• Restores structural support to prevent sagging or misalignment
• Reduces rattling and vibration caused by a loose or damaged bracket
• Helps maintain proper spacing so fasteners and connected parts fit correctly

• Disconnect power (and water, if applicable) before starting any repair
• Use the same screws/fasteners specified by the manufacturer; only state quantity if explicitly supplied
• Wear gloves to avoid sharp edges; support the assembly while removing/installing the bracket
• Test the appliance after installation to ensure proper fit and quiet operation