Frigidaire 137116700 Dryer High Limit Thermostat OEM Part

My Electrolux Frigidaire Gas Dryer stopped working and I got an error code E66 that the thermal limiter blew from over heating. The E66 code stops displaying after the initial code and you will then get a door open message. I replaced the thermal limiter and the thermostat just to be sure which part at the problem. The job is hard because you have to take apart the entire dryer and remove the drum. Would be a tough project to complete on your own.

Yes tested continuity on all sensors inside and found two to be faulty. I replaced three of them because frigidaire does not have an access panel and figured do them all while its apart. The parts were half the cost it was to have a repair man diagnos it and arrived within two days. I replaced the limiter the thermostat and the control thermistor.

Replaced Door switch, limiter and Thermostat. Repairman I called couldn't fix it. Youtube was great help.

Replaced senor on heat exchanger.

After looking up youtube videos on how to correct the "door open" error message I replaced the blown thermal fuse on the heater housing. I cleaned the exhaust hose and filter to like new condition. I even tested the cycling of the heat going from high heat to step down after 15 minutes with a thermometer to be sure it was not running on high heat 100% of the time (youtube video). The thermal fuse kept blowing. I found appliancepartpros on the internet and called tech support. The very helpful technician/parts expert advised to replace 2 other parts associated with this common problem (high limit thermostat and second thermal fuse on exhaust). I watched the videos on the website on how to install and it was very simple. I feel pretty confidant that this is going to fix the problem for good! Thank you!