Frigidaire Washer Dryer Combo Wire, Harness, Power Cord

This wiring harness connects the washer control board to console switches and sensors, restoring reliable electrical communication so the machine can receive user inputs and run cycles correctly. What it does

• Links the control board to door switch, cycle selectors, and other console components so commands register.
• Replaces damaged or frayed wiring that can cause intermittent operation or unresponsive controls.
• Helps stop electrical shorts, error codes, or failure-to-start symptoms related to broken control connections.
• Restores factory routing and connector fit for secure, vibration-resistant connections.

• One wiring harness as shown.

• Always unplug the washer or shut off power at the breaker before servicing.
• Match connector shapes and wire colors to OEM locations; avoid forcing connectors.
• Route harness along original clips and channels to prevent pinching or rubbing.

Control wire harness for washer dryer combo units. Connects control panel components. Replace if wires are frayed, connectors damaged, or harness broken.

This lower wiring harness connects the washer's lower electrical components so signals and power reach the motor, pump, and sensors. Replacing a damaged harness restores reliable electrical connections and reduces intermittent failures. What it does

• Routes power and signal lines to lower laundry components so they operate together.
• Restores lost or intermittent electrical connections that can cause spin, drain, or agitation failures.
• Helps stop shorts or arcing from frayed wires that trigger error codes or unexpected shutdowns.
• Supports secure plug-in connections for sensors, pump, and motor circuits.

• One lower wiring harness

• Disconnect power to the appliance before beginning any repair.
• Handle connectors carefully; match keyed plugs and route harness through original clips and channels.
• Inspect connector ends and wiring for damage; replace harness if insulation is cracked or terminals are corroded.
• Test full function after reconnecting power and before reassembling panels.

Wire harness that connects the dispenser assembly in your washer. Replace if wires are frayed, connectors are damaged, or the harness is broken or missing.

Control wire harness for washer dryer combo units. Connects control panel components including temperature switch. Replace if wires are damaged or frayed.