Parts for Bosch SHV43P13UC/53: Front Panel Parts

Removes residue, odor-causing soils, and food particles from dishwasher tub and gasket. Use monthly to eliminate unwanted odors and maintain peak performance.

Fix a dishwasher that won't start or runs continuously with a new control unit. Coordinates cycle timing and part sequencing for proper operation.

Fix a dishwasher that won't power on or reset with this on/off switch. Replaces worn or moisture-damaged switches. DIY-friendly installation.

Fix a dishwasher door that won't latch or stay closed. This door latch assembly secures the door during operation. DIY repair in 15-30 minutes.

This replacement switch restores reliable electrical control within your appliance. It opens and closes an electrical circuit to signal the control system, so power and functions respond consistently when the switch is actuated.

• Opens/closes an electrical circuit when the actuator is engaged
• Sends an on/off or selection signal to the control or main board
• Helps address: no response or no start, intermittent operation, stuck on/off state, or heat-damaged/burned terminals
• Direct replacement for the original switch on applicable units

• Disconnect power at the breaker and unplug the unit before servicing
• Access the control area to reach the switch; note wire locations or take a photo
• Transfer wires one at a time for correct orientation; ensure snug terminal connections
• Reinstall mounting hardware, reassemble panels, restore power, and test operation

This cable harness routes power and signals between components to restore reliable electrical connections. Replacing a damaged harness helps stop intermittent operation and eliminates exposed or broken wiring that can cause component failures. What it does

• Reconnects power and control signals between appliance modules and components.
• Replaces damaged, frayed or burned wiring that can cause shorts or loss of function.
• Commonly fixes intermittent operation, components that do not power on, or complete failure of a circuit.
• Maintains correct wire routing and secure terminals for safe, reliable operation.

• Disconnect all power before starting work to avoid shock or injury.
• Compare the harness to the original and follow the OEM wiring diagram for correct routing and terminal locations.
• Securely seat all connectors and use proper strain reliefs; avoid pinching wires when reassembling panels.

Dishwasher door frame assembly that secures outer and inner door panels. Replace if cracked, warped, or damaged, causing loose door fit or gaps.

Removes residue, odor-causing soils, and food particles from dishwasher tub and gasket. Use monthly to eliminate unwanted odors and maintain peak performance.

Fix unresponsive or missing dishwasher buttons with this control panel push button set. Restores function selection and original panel appearance.

This holder is a molded mounting bracket that secures internal components and helps maintain proper alignment for reliable operation. It replaces a worn or broken support to restore fit and function. What it does:

• Secures and supports the associated component to prevent movement or misalignment
• Restores proper positioning when a cracked or broken bracket causes rattling or loose parts
• Helps reduce vibration and intermittent contact that can cause noise or poor performance
• Fits where the original molded holder has failed or become distorted

• Disconnect power and shut off water before replacing the part
• Remove access panels as needed to reach the mounting location; retain screws or clips for reassembly
• Align the holder with existing bosses or screw holes and secure with the original fasteners
• If clips or adjacent parts are damaged, inspect and replace as necessary for a secure fit

Removes residue, odor-causing soils, and food particles from dishwasher tub and gasket. Use monthly to eliminate unwanted odors and maintain peak performance.