General Electric Freezer Hose Or Tube

This refrigerator water line is the plastic tubing that routes pressurized water through the appliance's water system. Replacing a cracked, brittle, or kinked line helps restore proper water flow and prevents leaks inside or around the unit.

• Carries water between the inlet valve and the refrigerator's water system components
• Helps maintain a sealed path for reliable flow to the dispenser and/or ice maker
• Replace if tubing is cracked, kinked, brittle, or leaking
• Common symptoms include puddling, dripping, reduced/No water at the dispenser, or ice maker not filling

• Disconnect power and shut off the water supply before servicing
• Note the original routing and clip locations; avoid sharp bends and kinks during installation
• Fully seat tubing into existing connectors/fittings on your model
• Turn water back on, check all connections for leaks, and purge air by dispensing water

This tube drain routes defrost and condensation water away from the refrigerator cabinet to the drain system, helping prevent pooling and ice build-up. It's a direct-replacement service part designed to restore proper water flow. What it does

• Channels defrost and condensation runoff from the evaporator area into the main drain or drain pan.
• Helps prevent water pooling inside the fresh food compartment or under crispers.
• Replaces cracked, kinked, clogged or deteriorated drain tubing that can cause leaks or frost buildup.
• Works with the existing drain funnel and heater components to maintain normal drainage.

• One tube drain

• Disconnect power to the appliance before beginning work; shut off water supply if the repair requires it.
• Remove interior panels as needed to access the evaporator/drain area; handle evaporator fins and plastic parts carefully to avoid damage.
• Ensure the tube is seated fully at both connection points and routed without tight bends or kinks to allow free drainage.
• After installation, run a small amount of warm water into the drain area to check for leaks.

This fill tube assembly delivers water to the refrigerator ice maker and dispenser area, restoring proper fill function and reducing leaks from cracked or worn tubing. A direct-fit replacement for the original fill pathway. What it does

• Routes water from the inlet to the ice maker/dispenser so ice trays and dispenser fill correctly
• Replaces cracked, split, or clogged tubing that can cause leaks or reduced water flow
• Helps stop intermittent filling or underfilled ice trays when the original tube is damaged
• Works with the refrigerator's existing valve and mounting points for a like-for-like repair

• One fill tube assembly

• Turn off power and shut off the water supply before starting any repair
• Inspect mounting clips and seals; reuse or replace as needed for a watertight fit
• Some models require removing interior panels or the ice maker for access; follow OEM instructions
• Test for leaks after reconnecting water and restoring power

This drain hose replaces a worn or damaged discharge line to restore reliable water removal. It gives a direct path for wastewater so the appliance can drain properly and helps prevent backups or leaks. What it does:

• Carries wastewater from the appliance to the household drain or disposal
• Restores proper draining when original hose is cracked, split, or clogged
• Helps stop leaks and pooling under or around the appliance
• Compatible with appliances that use this style of flexible drain tubing

• One drain hose

• Disconnect power and shut off water supply before replacing the hose
• Remove and replace the old hose, secure both ends with proper clamps or fittings
• Route the hose without kinks and check for obstructions before finalizing
• After installation, restore power/water and run a short cycle to check for leaks