General Electric Freezer Plug Or Insert

This exterior drain plug seals the washer's drain opening to prevent leaks and contain water in the tub during operation. It provides a simple replacement to restore a watertight seal at the appliance drain area. What it does:

• Seals the drain opening to help prevent water leaks from the tub or drain housing
• Helps maintain proper drainage by keeping debris out of the drain path
• Can stop visible water weeping or puddling near the base of the washer
• Replaces a cracked, worn or missing exterior drain plug to restore normal operation

• One exterior drain plug

• Disconnect power to the appliance and turn off water supply before starting any work
• Remove the appropriate access panel or lower kick plate to reach the drain opening
• Press or thread the plug into the drain opening as designed; snug by hand and avoid over-tightening
• Inspect the surrounding seal area and replace any damaged gaskets or housings if present; test for leaks after reinstalling panels and restoring power/water

This plug button is a small push-in cap that covers unused holes and secures trim or panels for a finished appearance. It helps keep debris and moisture out while providing a simple, low-profile finish on appliance surfaces. What it does:

• Covers exposed screw holes and openings to improve appearance and prevent dirt entry
• Helps secure lightweight trim pieces and panels by snapping into place
• Reduces chance of small-object ingress around mounting points
• Common replacement when original plug is cracked, missing, or worn

• Disconnect power to the appliance before working near electrical components.
• Install by aligning and pressing the plug squarely into the hole until it snaps in; remove with a flat tool if necessary.
• Do not force into undersized holes; replace with correct size if fit is tight or loose.
• If the plug secures a component, verify the component is properly seated before finalizing installation.

This vent plug door is the replacement front vent flap that covers the appliance vent opening and helps control airflow and block drafts when the appliance is not running. It restores a secure, sealed vent surface for proper ventilation. What it does

• Replaces a cracked, warped, or broken vent plug door to stop drafts and reduce debris entry
• Allows the vent to open during operation and closes when idle to limit air loss
• Restores proper vent sealing that can affect airflow and efficiency
• Visible, damaged, or stuck vent flaps are common signs this part is needed

• 1 vent plug door

• Disconnect power to the appliance before starting any repair
• Typically secures with a few screws; basic hand tools may be required
• Handle gently to avoid damaging the flap or surrounding trim during installation
• Follow the manufacturer's instructions for correct orientation and fit

This snap-in plug button replaces a worn or missing plastic cover used to close unused openings or secure small wiring/plugs on the appliance. It restores a finished look and helps keep out dust and debris. What it does:

• Snaps into a corresponding hole or recess to cover an opening
• Helps prevent dirt, moisture, and small debris from entering service areas
• Restores a missing or damaged cosmetic cover for a clean appearance
• Can reduce rattles or movement where a loose opening exists

• Disconnect power to the appliance before working near electrical components.
• Typically installs by pressing into the matching opening until it snaps into place.
• Use a plastic tool or fingertip to avoid scratching surrounding surfaces.
• Inspect mounting area and replace any broken retainers before installing.