General Electric Freezer Relay, Overload, Capacitor

This PTC start relay mounts on the refrigerator compressor and briefly energizes the start winding, then automatically opens as it warms. Replacing a weak relay helps restore reliable compressor starts and consistent cooling. What it does:

• Provides momentary power to the compressor's start winding at startup; the PTC element opens as it heats
• Helps ensure smooth compressor starts and reduces repeated start attempts
• Signs of a failed start device can include no cooling because the compressor won't run
• Clicking or buzzing from the compressor area every few minutes
• Compressor starts intermittently or stops shortly after starting

• Includes: 1 PTC start relay

• Disconnect power and pull the refrigerator forward to access the rear service area
• Remove the rear panel to reach the compressor compartment
• Unplug the wire harness and pull the old relay straight off the compressor terminals; note its orientation
• Push the new relay fully onto the compressor prongs, reconnect the harness, reinstall the panel, and restore power

This compressor controller is the electronic control module that manages compressor start/stop functions to help the refrigerator maintain proper cooling performance. It replaces a failed controller to restore normal compressor operation. What it does:

• Monitors and controls compressor start/stop cycles for stable cooling
• Resolves symptoms such as the compressor not running, intermittent cooling, or frequent compressor cycling
• Works with the appliance's existing wiring and mounting points to perform control functions
• Does not service sealed refrigerant components; intended only for electrical control of the compressor

• Always unplug the appliance before servicing to avoid electrical shock
• Verify power is disconnected and use a multimeter to confirm before touching wiring
• Handle the module and connectors carefully to avoid ESD or connector damage

This compressor controller is a direct replacement control module that regulates compressor start/stop and run cycles to help restore normal cooling performance in refrigerators when the original module fails. What it does:

• Controls compressor start and run sequences to maintain proper refrigeration.
• Helps prevent short cycling by managing compressor runtime.
• Can cause the compressor to run continuously or run irregularly if defective.

• Disconnect power to the appliance before starting any repair.
• Handle the module and PCB carefully; avoid static discharge and contact with moisture.
• Verify connector orientation and secure mounting; do not force connectors.

This capacitor helps the refrigerator's compressor start and run more reliably by supplying the motor with a brief boost of electrical energy. Installing a fresh capacitor can restore normal compressor starting and reduce hard-start symptoms. What it does

• Provides the electrical boost needed for compressor motor startup and stable running
• Helps prevent slow-starting or frequently-stopping compressor behavior
• Can reduce loud clicking or humming during start-up when the original capacitor fails
• Supports consistent cooling performance by enabling proper compressor operation

• One compressor capacitor

• Disconnect power to the appliance before beginning any service
• Capacitors can hold a charge; discharge and handle with insulated tools
• Inspect mounting and wiring for heat or oil damage and replace damaged components as needed

A run capacitor that helps the appliance motor maintain smooth, efficient operation by stabilizing voltage and phase. Replaces a worn or failing capacitor to restore consistent motor performance and reduce erratic cycling. What it does:

• Provides phase shift and stable voltage to the motor for steady running
• Commonly replaces capacitors that cause humming, weak motor start, or intermittent operation
• Helps prevent motor overheating and frequent tripping when functioning correctly
• Works with the appliance's electrical system to improve overall motor reliability

• One run capacitor

• Always disconnect power to the appliance before servicing to avoid shock
• Capacitors can hold a charge; discharge safely before touch or removal
• Inspect mounting, terminals, and wiring for damage; replace any compromised components