Wayne W Hoffman Estates , IL February 21, 2016 Appliance: Model GE DISHWASHER Top rack guide (wheels) where falling off I pulled the dishwasher out by removing screws that go into countertop. I then turned the adjustable screws on the front legs of the dishwasher enough to make sure I can slide the unit out. Slid the unit out a litte more than a foot. Moved the insulation off the sides saw the screws to put on the new guides removed the screws removed old guides put on new guides tighten screws and put the dishwasher back in place. Read More... 5 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 1-2 hours Tools: Adjustable Wrench, Nut Drivers, Socket Set
Jerry M Chicago , IL March 08, 2017 Appliance: Model GE DISHWASHER ZBD1800 Needed to replace apper and lower studs and rollers including guide rail brackets in my dishwasher I watched the video provided on the website and of course, the Guide Rail Bracket video was not available even though that was the hardest to replace. So I just had to move the dishwasher out from the cabinet and then remove the old Brackets by removing the holding screws and reuse the same screws for the new parts. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 1-2 hours Tools: Adjustable Wrench, Screwdrivers
Rob H Seattle , WA November 15, 2021 Appliance: Kenmore Electric Dryer 11067902790 Dryer no heat. Installed new heating element and both parts in #279769 (thermal cutoff and HL t-stat). Troubleshooting: Tested continuity at element (bad), thermal fuse (good), thermal cutoff (bad) and HL t-stat (good). Replaced both parts in #279769, just in case + the new element . Got spare thermal fuse just in case. All worked great. Took about 1 hour, but I'm slow. Your videos are great! Read More... Do-It-Yourself Rating: Repair Time Estimate: 1-2 hours Tools: Nut Drivers, Pliers, Screwdrivers, Socket Set
Charles B Cape May Ct House , NJ March 28, 2015 Replacement rollers Great easy install Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Nut Drivers
Christopher P Bergenfield , NJ December 15, 2017 The rail brackets rollers kept coming off if you were anything but gentle when pulling the dish tray out to load and unload I purchased four guide brackets and replaced the existing ones. It would have been good if the screws were included as the previous ones we rusted and difficult to turn however, WD40 fixed that issue Read More... Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers, Wrench Set