Gibson Freezer Parts

Shield component for upright freezers. Protects internal mechanisms from damage. Replace if cracked, broken, or missing to restore proper coverage.

Used to hold the original electrical components to the side of the compressor.

This small plastic clip secures the dishwasher drain hose to the pump assembly or discharge fitting, keeping the hose in place and helping prevent leaks or disconnection during operation. What it does:

• Holds the drain hose firmly to the pump or outlet fitting to maintain a watertight connection
• Prevents the hose from slipping free during drain cycles
• Helps stop water leaks and washing chamber flooding caused by a loose hose
• Useful when replacing a cracked or broken retaining clip

• One drain hose retaining clip

• Disconnect power and water supply before accessing the dishwasher lower access area
• Remove the access panel or kickplate to reach the drain hose and pump connection
• Use pliers or a flat tool to remove the old clip and snap the new clip over the hose/fitting until fully seated
• After installation, run a short drain cycle and inspect for leaks; re-secure if necessary

Interior liner for freezer door that holds insulation and mounting points. Replace if cracked, dented, warped, or broken to restore door structure and finish.

Wire storage basket for upright freezers. Holds and organizes frozen food items. Replace if your original basket is bent, damaged, or missing.

Foam insulation sleeve that wraps around the defrost drain tube. Replace if worn, missing, or damaged to prevent condensation and maintain proper insulation.

White access panel for chest and freestanding freezers. Covers internal components and provides service access. Replace if cracked, discolored, or missing.

Replacement control housing cover for freezers. Snaps over the control panel assembly. Replace if cracked, broken, or missing to restore appearance.

Freezer light lens cover protects the interior bulb from moisture and damage. Replace if cracked, yellowed, or broken to restore safe lighting.

Outer door panel for upright freezers. Replaces damaged, cracked, or discolored exterior panels. Restores appearance and structural integrity.

This cable clip secures a refrigerator's wire harness or control cables, keeping wiring routed and protected to prevent pinching or contact with moving parts. A small but important retainer for safe, tidy internal wiring. What it does:

• Holds and routes wire harnesses or cables to prevent interference with drawers, doors, or moving components
• Reduces wear and chafing on wires by keeping them away from sharp edges and heat sources
• Helps maintain reliable electrical connections by preventing strain on harnesses
• Commonly replaced when clips are broken, cracked, or missing and wires become loose or misrouted

• Turn off power to the appliance before accessing internal wiring
• Install by snapping clip onto designated frame or mounting boss and seating wire(s) into the clip
• Replace any damaged wiring or connectors discovered during installation