Gibson Range Panel Parts

Genuine Frigidaire part

Gibson Lower Drawer (Range Bottom)

By: Frigidaire

Part Number: 316408706

This lower drawer replaces a damaged or missing bottom drawer on your range, restoring smooth slide action and a flush, finished look so the lower compartment operates correctly and the appliance is complete again.

Forms the pull-out compartment beneath the oven for convenient access
Interfaces with the drawer slides to open and close smoothly
Restores proper alignment and full closure at the base of the range
Typical symptoms: drawer jams, falls off tracks, sits unevenly, or is bent/dented

What's included: 1 drawer Install notes:

Disconnect power and shut off gas; allow the range to cool before servicing
Pull the old drawer out and lift to disengage from the slides; transfer any reusable parts as needed
Set the new drawer onto both slides evenly and test for smooth travel and full closure
If the drawer doesn't seat flush, re-check slide engagement and appliance leveling

$74.32

Compare At:: $88.44
You Save:: $14.12

IN STOCK

Ships Tomorrow Guaranteed

Add to Cart

Genuine Frigidaire part

Gibson Panel

By: Frigidaire

Part Number: 316400142

$69.11

Compare At:: $73.07
You Save:: $3.96

IN STOCK

Ships Tomorrow Guaranteed

Add to Cart

Genuine Frigidaire part

Gibson Liner`Low Broil

By: Frigidaire

Part Number: 316236401

$87.95

Compare At:: $104.66
You Save:: $16.71

Out Of Stock

Usually ships within 4 - 14 days

Add to Cart

Genuine Frigidaire part

Gibson Panel

By: Frigidaire

Part Number: 316400143

$69.11

Compare At:: $73.07
You Save:: $3.96

Out Of Stock

Usually ships within 4 - 14 days

Add to Cart

Genuine Frigidaire part

Gibson Panel (Control Console)

By: Frigidaire

Part Number: 316401800

This replacement control console panel restores the front trim that holds the range's controls and display, giving a finished appearance and secure mounting for buttons and the user interface. Fits factory specifications for a direct match. What it does:

Replaces a cracked, faded, or bent front control panel to restore appearance
Secures control buttons and display components in the correct position
Helps eliminate loose or rattling trim around the control area
Works with existing switches, buttons and electronic modules when they are undamaged

What's included: One control console panel Install notes:

High-level replacement; remove power to the appliance before starting
Handle with care to avoid scratching the finish or damaging attached clips
Retain all screws and fasteners; transfer any brackets or brackets included with the original
If switches, electronic modules, or wiring are damaged, replace those components instead of reusing them

$101.95