Parts for Ge UVH13013M2DS: Hood Assembly Parts

This hood damper assembly replaces the vent flap that opens and closes to let exhaust air exit your range hood or over-the-range vent. It restores proper airflow control and helps prevent backdrafts when the hood is off. What it does:

• Opens to allow exhaust airflow during venting and closes to block outside air when not in use
• Prevents backdrafts and reduces drafts from entering the kitchen through the hood vent
• Stops rattling or sticking caused by a worn or damaged damper flap or hinge
• Helps restore normal ventilation performance when the original damper is broken or jammed

• One hood damper assembly (damper flap with attached hinge)

• Disconnect power to the range hood or appliance before starting any work
• Handle sheet-metal edges carefully; wear gloves to avoid cuts
• Basic hand tools are typically required; align hinge and test damper operation before finishing

A small retaining spring washer that provides tension and helps secure fasteners on appliance assemblies. Replaces worn or damaged washers to restore proper clamp and prevent loosening of mounted components. What it does:

• Applies spring tension to a fastener or shaft to maintain clamp and alignment
• Helps prevent bolts or shafts from backing out under vibration
• Commonly replaced when missing, flattened, or corroded
• Symptoms of a failing washer include loose parts, increased vibration, or rattling

• One spring washer

• Disconnect power before servicing electrical appliances
• Use the correct tools and exact OEM part number for fitment
• Inspect mating parts (bolt, shaft, housing) for wear and replace if needed

Charcoal filter traps cooking odors in recirculating range hood vent systems. Replace when saturated to restore effective odor reduction. Verify fit.

Replace your range hood's LED light assembly to restore bright, energy-efficient illumination. Fits specific models—verify compatibility before ordering.

Metal mesh grease filter captures airborne grease and cooking residue to protect your range hood's vent and fan. Replace when clogged or damaged. Verify fit.

This interface board routes control and display signals between the microwave/TV assembly and the hood, restoring communication for vent, light, and display functions. It's a direct-replacement control interface designed for factory fit and operation. What it does

• Transfers interface and control signals between the oven/microwave TV module and the hood/vent assembly.
• Restores responsive vent fan and hood lighting when a failed interface board causes loss of control or display communication.
• Helps resolve intermittent or no-response issues tied to the interface connection (shorts or failed circuitry).
• Works as the communication/connector board used in the appliance's control system.

• One interface board

• Disconnect power (unplug or shut off breaker) before beginning any service to avoid shock.
• Inspect connectors and wiring harness for damage; replace any frayed or corroded leads before installing the board.
• Handle the board by edges and avoid touching components; use proper ESD precautions if available.

This speaker wiring harness connects the control board to the oven/microwave chime or speaker so your appliance can signal status tones. It replaces a damaged or disconnected cable to restore audible alerts and proper control-panel feedback. What it does

• Carries audio/chime signal from the control board to the appliance speaker
• Restores missing or intermittent beeps, chimes, or other control-panel sounds
• Replaces frayed, burnt, or broken wiring and damaged connector ends
• Ensures a secure, correct electrical connection between components

• Disconnect power (unplug appliance or shut off circuit breaker) before installation
• Match connectors and routing to the original harness; do not force connectors
• Inspect mating connectors and boards for damage before connecting