Huskee / Husky Tiller Parts

Tiller not engaging or tines not turning? The worm drive shaft transfers power to the tines. Common failure part in rear-tine tillers. Moderate DIY repair.

Engine shroud assembly for walk-behind lawn mowers and tillers. Protects internal components from debris. Replace if cracked, broken, or missing.

Replacement fuel tank for lawn mowers. Mounts to mower exterior to hold fuel supply. Replace if cracked, leaking, damaged, or missing. Direct fit part.

Muffler spark arrestor screen that installs inside the exhaust system. Replace if cracked, clogged with carbon buildup, or missing for safe operation.

Muffler assembly that connects to the exhaust tube on lawn mowers and garden equipment. Replace if cracked, rusted, or damaged to restore proper exhaust flow.

Replacement flywheel for small engines. This rotating wheel component stores rotational energy. Order a new one if yours is cracked, rusted, or damaged.

This is a crankcase gasket that seals the crankcase cover to the engine block on a lawn mower. It prevents oil from leaking out of the engine and keeps contaminants from entering the crankcase. Replace this gasket if you notice oil pooling beneath the engine, visible oil seepage around the crankcase cover, or if the gasket is torn or deteriorated.

Seals the crankcase halves to prevent oil leaks in lawn mowers, tillers, and outdoor power equipment. Replace if oil is leaking or during repairs.

Seals the dipstick oil fill tube on mowers and small engines. Replace if leaking oil or cracked to prevent engine damage. Confirm fit by model.

Engine won't start or runs rough? This camshaft assembly converts rotational motion to reciprocal motion for proper engine operation. Moderate DIY repair.

This replacement part is an oil seal. This is a genuine replacement part made by MTD. This part is used to ensure that oil and other fuel cannot escape from the tank. The seal prevents it from leaking during use to ensure the engine is able to run properly. A new oil seal might be needed if the current one has been damaged. If the seal is worn down and thinner than before, it can cause leaks and oil waste. If this is the case, the seal should be replaced immediately. Oil leakage can cause other issues within the machine. Refer to the owner's manual for more information on how to replace this part. This is a genuine OEM replacement part. This part is sold individually and is sourced directly from the manufacturer.

Oil fill tube assembly for small engines on mowers, tillers, and chippers. Replace if cracked, damaged, or leaking. Installs on engine block.

Seals cylinder and piston to prevent combustion gas leaks. Replace if engine uses excess oil, loses power, or has poor compression. Verify fit.

Replace a cracked or damaged breather valve base causing oil leaks or pressure issues. Direct-fit part for lawn mowers and outdoor power equipment.

Can't check oil level accurately? This dipstick assembly lets you monitor engine oil to prevent damage. Simple 5-minute replacement for mowers and tillers.