Parts for Lg LMXC23746D: Ice Maker Part Parts

Removes contaminants for clean, fresh-tasting water and ice. Replace every 6 months or 200 gallons to maintain water quality. Verify fit with your model.

This holder assembly is a structural mounting piece that supports and secures an internal component in your appliance. Replacing a cracked or worn bracket helps restore proper alignment and keeps parts stable during everyday use.

• Provides a rigid mounting point for the attached component
• Keeps parts aligned to reduce movement and vibration
• Helps prevent rattling or noise from loose mounts
• Common signs of failure: visible cracks/broken tabs, looseness, or parts that won't stay seated

• Disconnect power and, if applicable, turn off the water supply before service
• Note the orientation of the original part to match fitment
• Reuse existing mounting screws or hardware unless the manufacturer specifies otherwise
• Do not overtighten fasteners; the secured component is fully seated and stable

Ice won't dispense but ice maker works? The auger motor drives ice from the bin to the chute. Moderately easy repair with our video guide and DIY tips.

Ice maker stopped working or producing misshapen ice? This complete assembly replaces a faulty ice maker. Moderate DIY repair, about 1 hour with basic tools.

Fix an icemaker that won't make ice, clicks but doesn't dispense, or leaks water. This assembly replaces failed units. DIY install in 10 minutes.

Ice bin cracked, warped, or causing weak dispensing and jams? This ice bucket assembly stores and delivers ice to your dispenser. Easy DIY repair.

Secures and supports refrigerator door pivot for proper alignment and smooth operation. Replace when door sags, seals poorly, or binds. Confirm fit with model.

Molded door shelf cover for the home bar compartment. Replaces cracked, broken, or missing covers. Installs on the refrigerator door for a finished look.

Replacement door hinge assembly for your refrigerator. Installs on the cabinet to support the door. Replace if cracked, bent, or worn for proper alignment.

The Lever Cover is an OEM part for LG refrigerators. This cover fits neatly over the freezer door lock mechanism, protecting its internal lever and hardware.

Causes of a bad lever cover can include damage from regular opening and closing of the freezer door over time. Accidental impacts or heavy impacts from moving the refrigerator could also crack or weaken the plastic material.

Symptoms of a bad lever cover include:

• Exposure of the lock mechanism that allows dust and debris to enter
• Improper shielding of lock parts leading to potential jamming issues
• Cracking or breakage of the plastic allowing outside contaminants inside

This OEM LG part is also compatible with some Kenmore models.

The Dispenser Gasket is an OEM part for LG refrigerators. It is a seal that helps create an airtight barrier around the dispenser area, preventing air leaks and maintaining the desired temperature and humidity levels inside the refrigerator.

Causes of a bad dispenser gasket can include wear and tear over time, exposure to extreme temperatures or UV light, or physical damage from mishandling or improper installation.

Symptoms of a faulty dispenser gasket include:

• Air leaks or drafts around the dispenser area
• Condensation or frost buildup near the dispenser
• Higher than normal energy consumption due to the fridge working harder to maintain the desired temperature
• Difficulty in opening or closing the dispenser door

This OEM LG part is also compatible with some Sears/Kenmore refrigerator models

Replaces a cracked, broken, or missing ice dispenser door handle on your refrigerator. Installs on the exterior dispenser for easy ice access.

Seals the ice bank door to prevent warm air from melting ice and causing clumping. Replace if ice melts, refreezes into clumps, or frost forms around the bin.