Parts for Crosley CFD28WIQWA: Ice Maker Parts

Fix a refrigerator not making ice or dispensing water with a new water inlet tube. Restores proper flow from valve to ice maker and dispenser.

Ice bin filled with solid ice block? Cracked ice tray leaking water into bin? This ice maker assembly fixes freezing issues. 15-minute DIY install.

Ice maker freezing over or heavy frost buildup? This defrost thermostat controls your refrigerator's defrost heater. Moderate DIY repair with video guide.

Fixes refrigerator not cooling properly or freezer frost buildup. This evaporator coil absorbs heat to keep food cold. Moderate DIY repair project.

Fix ice buildup in freezer or water leaking into fridge. This defrost heater melts frost from evaporator coils during defrost cycles. Moderate DIY repair.

Replaces a cracked, chipped, or missing housing cover on your refrigerator. Restores exterior appearance and shields internal components from dirt.

No water or ice from your refrigerator? A faulty water inlet valve often causes this. Easy DIY repair with basic tools in under 30 minutes.

Fix a cracked or missing control panel cover that exposes switches or causes misaligned knobs. This housing cover protects internal components and restores a clean finish.

Replacement cover that restores appliance appearance and protects internal components from dirt and damage. Installs in place of a worn, cracked or missing cover to keep controls and wiring safely concealed and the unit looking finished. What it does:

• Protects the control area and internal components from spills, dust, and accidental contact.
• Hides and secures wiring and mounting points to prevent snagging or tampering.
• Restores the appliance's finished look when the original cover is scratched, cracked, broken, loose, or missing.
• Helps reduce the chance of debris entering sensitive areas that can affect performance.

• One replacement cover.

• Disconnect power (unplug or shut off circuit breaker) before attempting any service.
• Basic hand tools are typically required; support the cover while removing fasteners to avoid dropped parts.
• Handle edges carefully to avoid cuts and to prevent scratching adjacent surfaces.
• Refer to the appliance's service manual or model-specific instructions for exact removal and reinstallation steps.

Foam insulation panel for refrigerators. Installs inside cabinet walls to maintain temperature efficiency. Replace if cracked, compressed, or missing.

Fix refrigerator electrical issues with this replacement wiring harness. Restores power connections between components. Moderate DIY repair, 30-60 minutes.

Mounting screw for refrigerator components and panels. Replaces lost, stripped, or damaged screws. Essential hardware for secure assembly.

Secures refrigerator grille or trim to cabinet, preventing rattles and gaps. Replace when broken or missing to restore proper panel alignment. Verify fit with your model number before ordering.

Small retainer clip that secures components, panels, tubes, or wires in place inside your refrigerator. Replace when worn, broken, or missing to restore fit.

Replacement mounting screw for refrigerators and freezers. Secures shelves, handles, panels, and brackets. Replace missing, stripped, or rusted screws.

Ice buildup in fresh food section or around evaporator? This air handler housing kit stops warm-air leaks that cause frost and temperature swings. 30-min repair.