Need Help?
Call or text
Oven won't heat, overheating, or controls unresponsive? This range control board manages temperature and cooking functions. Moderate DIY repair.
Replaced the oven controller. This needed the only removal of six hex screws securing the back guard rear shield, two-wire plugs on the control unit, and four Phillips screws. All are easily accessible. The only difficulty came from an apparent model design change that separated the control unit and the overlay - the labels for the control buttons (items 20 and 20a in the backyard parts diagram). Mine is a single unit (the overlay could not be removed without damage) led to the assumption that... Read more
Microwave won't heat or shows F1E5 error? The inverter regulates power to the magnetron. Intermediate repair, 1-2 hours with full disassembly required.
Replaced numerous items including this Inverter and two control boards but the Magnetron was the ultimate solution. The tip was clearly burned through when I removed the original. Read more
Fix F10 error codes, blank displays, or temperature fluctuations. This oven control board restores bake/broil cycles and keypad response in your range.
Replaced the control board. Read more
Range not heating or display blank? The main control board coordinates all cooking functions. This electronic repair requires basic skills and 30-45 minutes.
Fix burners that won't ignite, slow clicking, or repeated sparking. This spark module controls ignition for gas range surface burners and oven.
Replaced ignitor. Watch the u-tube videos for removing and replacing the board and ignitor. Read more
Fix oven that won't heat or igniters that won't glow. This gas range control board manages burner and oven operations. DIY-friendly, installs in 15 minutes.
So initial thought was bad bake igniter. I'bve replaced this before so I replaced it again and it wouldn't glow. Checked broil igniter and same thing, no glow. Checked voltage at molex connector for bake igniter and it went from 6.6v to 3.4v when triggered to glow -- well below the 120v expected. Ordered new clock/controller and overlay -- it shipped the next business day! Removed a handful of screws from the back panel to expose the clock/controller and removed/ replaced it with new... Read more
Range won't turn off or functions stay powered on? This relay board controls electrical flow to range components. Common fix for stuck-on appliances.
If your oven control flickers or resets randomly, the transient suppressor may have failed. This part protects the control board from power surges.
Microwave not heating or showing F1 E5 error? This inverter board converts voltage to power the magnetron. Requires tech sheet for testing procedures.