Inglis Cap Or Cover

The Lint Screen Housing Assembly is an OEM part for Whirlpool dryers. It houses the lint screen, which captures lint and debris from the drying cycle, preventing it from clogging the dryer vent and ensuring efficient airflow.

Causes of a bad housing assembly can include cracks or breaks due to frequent handling, wear and tear over time, or accidental impact. A faulty housing can compromise the lint screen's ability to trap lint effectively, leading to potential ventilation issues.

Symptoms of a bad lint screen housing assembly include:

• Lint screen not fitting properly
• Visible cracks or damage to the housing
• Increased lint buildup inside the dryer
• Longer drying times due to restricted airflow

This OEM part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.

This pulley cover encloses the drive belt and motor pulley at the base of the appliance. It protects moving parts from debris and contact, helping reduce noise and wear when the original cover is cracked, warped, or missing.

• Covers the drive belt and motor pulley to keep out dust and debris
• Helps prevent foreign objects from contacting moving parts
• Restores proper clearance to reduce rubbing or scraping noises
• Common signs it's needed: cracked/missing cover, rattling from the base, visible rub marks on the cover or belt

• Disconnect power and, if applicable, shut off water supply before servicing
• Access the underside per your service manual; support the unit securely if tilting
• Reuse existing mounting screws; do not overtighten to avoid damaging the plastic
• Rotate the belt/pulley by hand after installation to confirm free movement and no contact

This lid lock bezel is the plastic trim that mounts on the washer's top panel around the lid lock. It supports and protects the lock opening so the latch aligns correctly and the area looks clean and finished.

• Provides mounting/trim for the lid lock/switch assembly on the top panel
• Helps keep the lock aligned with the lid strike for reliable engagement
• Replaces cracked, broken, or missing bezel that leaves the lock loose or exposed
• Common signs include a loose or wobbly lock, difficulty latching the lid, or cosmetic damage around the lock opening

• Disconnect power and water supply before servicing
• Access the top panel (release spring clips or remove screws per model)
• Remove screws securing the lid lock, lift out the old bezel, position the new bezel, and reinstall the lock using existing fasteners
• Test operation before reassembly