Inglis Knob, Dial & Button
Genuine Whirlpool part
By: Whirlpool
Part Number: WP8536939
This is a D-shaped knob insert or spring clip that fits inside a control knob and connects it to the control shaft on the dryer's front panel. It ensures the knob grips the shaft properly so you can turn the timer or selector. Replace this insert if your control knob spins freely without engaging the shaft or if the knob feels loose and won't stay in position.
Do-It-Yourself Stories from Customers like You
Washer would not start due to non working lid latch Corrinne E. • Batavia , IL • September 27, 2019
I purchased the lid latch assembly and the lid switch strike. Following the clear video instructions for each part, my handy teenage son was able to remove the lid latch assembly and replace it with the new part as well as the lid switch strike. The washer is back to working perfectly for under $100. Appliance Parts Pros carry the parts to repair and at a lower cost than other online retailers. I saved about $30 compared to the other online site and I saved a service call fee. I'm so glad I...
Read more
More
$9.63
- Compare At:
-
$11.56
- You Save:
-
$1.93
Genuine Whirlpool part
By: Whirlpool
Part Number: WPW10711289
This is a control knob used on dryers, typically for the timer or cycle selector. It attaches to the timer shaft and allows you to select drying cycles and settings. Replace this knob if it is cracked, broken, or if the D-shaped mounting hole has worn out, causing the knob to spin freely without engaging the timer shaft.
Do-It-Yourself Stories from Customers like You
Dryer knob broke off. The timer was going out Steven J. • San Antonio , TX • June 17, 2023
I followed YouTube for instructions. Had a slight problem removing stems, but got it done.
Read more
More
$9.63
- Compare At:
-
$11.56
- You Save:
-
$1.93
Genuine Whirlpool part
By: Whirlpool
Part Number: WPW10251309
This is a push button switch used to start and stop the wash cycle on a washing machine. It mounts on the control panel and engages the machine's control circuit when pressed. Replace this button if it feels loose, does not click properly, or the washer fails to start or stop when pressed.
Do-It-Yourself Stories from Customers like You
Start/pause rubber button was worn out. Loretta B. • El Cajon , CA • August 31, 2020
Replaced the rubber button.
Read more
More
$51.95
- Compare At:
-
$61.30
- You Save:
-
$9.35
Genuine Whirlpool part
By: Whirlpool
Part Number: WPW10453947
This knob assembly replaces the "modifier" control knob on the console so you can adjust settings smoothly and reliably again. Restore a secure, positive-turn feel when the original knob is cracked, stripped, or missing.
- Attaches to the control shaft to select and adjust options/settings
- Replaces knobs that are cracked, broken, or missing
- Fixes a knob that spins freely, slips, or won't turn the control
- Restores proper selection and tactile feedback during use
What's included: 1 knob assembly Install notes:
- Disconnect power to the appliance before servicing
- Pull the old knob straight off the shaft; avoid prying against the panel
- Align the flat/splines on the new knob with the shaft and press on firmly until fully seated
- The pointer aligns with the panel markings before use
More
$37.51
- Compare At:
-
$44.64
- You Save:
-
$7.13