Kenmore / Sears Freezer Door

This inner panel is a factory-style replacement trim piece that restores the interior finish and protective surface of the appliance door. It matches the original white finish for a consistent, clean appearance. What it does:

• Replaces a cracked, scratched or discolored inner door panel to restore appearance
• Protects internal door components from spills and everyday wear
• Helps maintain a proper seal and door alignment by restoring original fit
• Designed to match OEM fit and mounting points for a straightforward swap

• Remove power to the appliance before starting any repair
• Typical install requires removing the door outer panel and disconnecting lightweight clips or fasteners
• Handle part carefully to avoid cosmetic damage; use appropriate tools and a second set of hands for larger doors

This replacement washer lid restores the top cover that keeps the wash tub closed during operation, helping contain water and suds and allowing the lid safety switch to function properly. Fits the original top-load washer configuration. What it does

• Covers the washer tub to prevent water and detergent from escaping during cycles
• Works with the lid safety/interlock so the machine can operate when closed
• Replaces cracked, warped, or missing lids that won't seal or latch correctly
• Helps reduce noise and keeps the wash area protected from debris

• Disconnect power and water supply before starting any repair
• Remove and reinstall using the original hinge screws or mounting hardware
• Align lid with hinge pins and test that it opens, closes, and latches smoothly
• Verify switch engagement and operation after installation

Replaces the exterior door skin on your freezer. Restores appearance when the original panel is dented, scratched, corroded, or worn. Mounts to door frame.

This white top lid replaces a damaged or discolored washer lid to restore a clean appearance and proper cover function. Fits the original hinge and latch locations for straightforward replacement. What it does

• Replaces a cracked, warped, or faded washer lid to help keep the washer tub covered and prevent debris from entering
• Restores correct mating with the hinge and lid latch so the lid stays closed during use
• Helps maintain the appliance's original look when the original lid is cosmetically damaged
• Compatible with models that use the OEM part number 216130118

• One (1) white top lid

• Basic hand tools are typically required; support the lid during removal/installation to avoid dropping or damaging other components
• Disconnect power to the appliance before beginning any repair to avoid electrical or mechanical hazards
• Inspect hinge, latch, and mounting hardware for wear and reuse or replace as needed