Kenmore / Sears Range / Cooktop / Oven Bracket & Flange

This mounting bracket secures internal panels or components to the appliance frame, restoring stable support and alignment for proper operation. Use when a bracket is bent, broken or missing to reduce rattling and keep parts positioned correctly. What it does:

• Anchors panels or components to the cabinet/frame to prevent movement and vibration
• Restores proper alignment of doors, panels or internal assemblies
• Stops rattling or buzzing caused by loose or damaged support hardware
• Helps maintain safe clearance between parts and wiring or moving components

• Disconnect power to the appliance before starting any repair
• Basic hand tools typically required; follow OEM instructions for correct fastener locations
• Inspect adjacent fasteners and mounting surfaces; replace any damaged screws or clips
• If bracket is corroded or severely deformed, replace rather than re-bend to ensure proper fit

This mounting bracket provides a secure support point for the appliance assembly where it attaches to the cabinet or adjacent components, helping maintain proper alignment and stable operation. What it does

• Secures panels or components to the appliance frame to prevent movement or sagging
• Keeps aligned parts properly positioned to reduce noise and wear
• Helps restore fit and finish after repair or component replacement
• Common symptom: loose, misaligned, or rattling panels near the mounting location

• Installation requires basic hand tools; disconnect power before servicing appliances with electrical components
• Retain original fasteners when possible; replace any stripped or damaged screws
• Inspect mating surfaces for damage or corrosion and clean before installing the bracket

This oven safety valve bracket secures the gas safety valve in place to keep the valve aligned and stable during operation. It replaces a worn, bent, or broken bracket to help maintain safe, consistent gas valve positioning. What it does:

• Holds the oven gas safety valve securely to the chassis to prevent movement or misalignment
• Helps maintain consistent valve positioning for reliable burner operation
• Commonly replaced when the bracket is cracked, bent, or missing hardware

• Always shut off gas supply and disconnect power before servicing gas components
• Remove access panels to reach the valve; retain all fasteners for reassembly
• Check valve alignment and gas connections after installation; do not overtighten mounting hardware