Kenmore / Sears Range / Cooktop / Oven Bumper, Bushing, Grommet Parts

Push-in plug button that covers openings in the oven bottom panel. Replace if cracked, missing, or broken to keep debris out and maintain a clean finish.

Rubber grommet plug that seals the light switch opening in your range control panel. Replace if cracked, torn, missing, or no longer providing a tight seal.

This snap bushing is a push-in grommet that secures and protects wiring where it passes through sheet metal openings, helping prevent wire chafing and wear. It's a simple replacement that restores proper wire routing and protection. What it does:

• Holds wiring or harnesses in place at panel openings to prevent rubbing and abrasion
• Cushions wires against sharp edges to reduce the risk of wire damage and shorts
• Maintains correct wire routing to prevent pinching when panels are reassembled
• Common symptom: visible chafed insulation or loose wiring at an opening

• One snap bushing (quantity: 1)

• Disconnect power to the appliance before beginning any work to avoid shock or injury
• Access the panel or opening where the wiring passes through; remove any retaining screws or clips as needed
• Press the bushing into the hole until it snaps fully into place, then route the wire through the center
• Inspect surrounding wire insulation and replace or repair any damaged wiring before reassembly

Fills the gap behind your oven door handle for proper spacing and alignment. Replace when cracked, broken, or missing to restore a secure, finished look.

This spacer positions and separates mounting components to maintain proper clearance and alignment, helping panels and hardware fit securely. It prevents rubbing and keeps assemblies stable for quieter, correct operation. What it does:

• Maintains required gap between panels or mounting surfaces to prevent binding or interference
• Keeps screws, brackets, and panels aligned for a proper fit
• Reduces vibration and rattling caused by loose or misaligned parts
• Helps restore proper clearance when replacing worn or missing spacers

• Disconnect power before accessing internal panels or fasteners
• Replace like-for-like; spacer location and orientation during removal
• Handle surrounding trim and panels carefully to avoid damage
• If fasteners are damaged or stripped, replace them rather than over-tightening