Kenmore / Sears Range / Cooktop / Oven Clip Or Clamp

This cable clip secures a refrigerator's wire harness or control cables, keeping wiring routed and protected to prevent pinching or contact with moving parts. A small but important retainer for safe, tidy internal wiring. What it does:

• Holds and routes wire harnesses or cables to prevent interference with drawers, doors, or moving components
• Reduces wear and chafing on wires by keeping them away from sharp edges and heat sources
• Helps maintain reliable electrical connections by preventing strain on harnesses
• Commonly replaced when clips are broken, cracked, or missing and wires become loose or misrouted

• Turn off power to the appliance before accessing internal wiring
• Install by snapping clip onto designated frame or mounting boss and seating wire(s) into the clip
• Replace any damaged wiring or connectors discovered during installation

Wire clip secures electrical connections to heating elements in ranges. Replace if worn, cracked, or loose to restore proper contact. Verify fit with model.

Secures components inside your range or oven. Replace if broken, loose, or missing to prevent rattling and ensure proper part positioning. Confirm fit.

Secures wiring harnesses in your range. Replace if broken, loose, or missing to prevent wire damage. Verify fit with your model number before ordering.

Secures the clock assembly to the control panel on your oven. Replace if clips are broken or missing to properly mount the clock. Verify fit with model number.

Fastener clip secures components in gas ranges. Replace if broken, loose, or missing to restore proper attachment. Verify fit with your model number.

This clip is a small mounting retainer used to secure panels, trim, or wiring inside the refrigerator. It restores proper fit and reduces rattling or loose parts for a quieter, safer appliance. What it does

• Holds panels, trim pieces, or wiring harnesses in place to prevent sagging or separation
• Stops vibrations and rattling caused by loose components
• Prevents wiring from rubbing or catching on moving parts
• Helps maintain correct alignment of removable trim and access panels

• Inspect the mating surfaces for damage; replace any broken mating tabs before installing the clip
• Push the clip into the mounting hole until it snaps securely; verify the retained part is firmly seated
• Disconnect power to the appliance before working near electrical components
• Use hand tools only and avoid force that could break adjacent plastic parts