Kenmore / Sears Range / Cooktop / Oven Screws, Nuts, Washers

A truss-head shoulder screw used where a short, smooth bearing surface and a wide head are needed for pivoting or locating parts. Replaces worn or missing screws to restore proper alignment and movement. What it does:

• Provides a smooth, stepped shaft (shoulder) for parts to pivot or slide on
• Secures components while maintaining precise spacing and alignment
• Stops looseness that can cause rattling, binding, or uneven movement
• Works in assemblies where a wide truss head prevents pull-through

• Use the correct screwdriver or bit to avoid stripping the truss head
• Do not overtighten; torque just enough to secure the part while allowing intended movement
• If working near electrical components, disconnect power to the appliance first

This 10-16 x 1-1/4 screw secures appliance panels and components, restoring proper fit and preventing loose parts. Use it when fasteners are missing, stripped, or causing rattle and misalignment. What it does:

• Fastens trim, brackets, or interior panels to restore secure attachment
• Stops rattling or vibration caused by loose hardware
• Replaces missing or damaged screws to maintain safe operation
• Matches OEM thread and length for correct fit in specified locations

• Disconnect power and empty appliance as needed before servicing
• Use the correct screwdriver or bit to avoid cam-out or head damage
• Do not overtighten; snug until parts seat to prevent striping or cracking
• Replace all matching screws for consistent fit

This replacement nut secures threaded fasteners on compatible Frigidaire appliances to hold panels and components in place. It restores proper fastening where a stripped, missing, or damaged nut causes loose parts or noise. What it does:

• Secures bolts and studs to keep panels, brackets, and components mounted firmly
• Prevents fasteners from backing out and reduces vibration-related noise
• Common symptom: loose or rattling panels or components near the fastener location
• Replaces corroded, rounded, or stripped nuts to restore reliable fastening

• Disconnect power to the appliance before servicing to avoid shock or injury
• Use the correct wrench or socket to avoid rounding the nut; match thread and size exactly
• Tighten snugly but avoid overtightening to prevent stripped threads or warped components
• If threads are damaged, replace both the nut and the mating bolt/stud for a secure fit

This rivet is a small metal fastener used to secure panels, trim, and small appliance components so assemblies stay stable and aligned. Replacing a damaged or missing rivet restores proper fit and reduces noise from loose parts. What it does:

• Secures sheet metal panels, trim pieces, or small brackets in place
• Keeps components aligned and prevents shifting or sagging
• Replacing worn or broken rivets can stop rattling or loose-feeling panels
• Use when a rivet is missing, bent, sheared, or otherwise damaged

• Typically installed with a pop-rivet tool or pressed into place depending on application
• Remove damaged rivets by drilling out the center or cutting them free before installing the replacement
• Wear eye protection and follow tool manufacturer safety instructions