Kenmore / Sears Range / Cooktop / Oven Support Parts

Left-side backguard support bracket secures the backguard to your oven frame. Replace if bracket is cracked, broken, or missing to restore stability.

Mounting plate that secures the oven to the cabinet or wall. Replace this metal support plate if it's bent, rusted, or missing to ensure proper installation.

Replace your microwave's support plate if cracked, broken, or missing. This structural component mounts inside the cavity to support internal parts.

Replace your oven's cavity support plate if the original is cracked, broken, or missing. This structural component installs inside the oven to support the cavity.

Top support plate for gas ranges. Mounts beneath the cooktop surface to provide structural reinforcement. Replace if cracked, bent, or damaged.

Support plate that mounts inside your gas range to provide structural reinforcement. Replace if the plate is cracked, broken, or damaged during service.

Support plate for gas range burners. Mounts beneath burner assembly to provide stable base. Replace if cracked, warped, or missing to restore proper fit.

Left-hand broiler support plate for gas ranges. Secures the broiler assembly in place. Replace if cracked, warped, or no longer holding components firmly.

This plate is a flat mounting plate used to secure internal components and assemblies on compatible Frigidaire appliances. It provides a stable attachment point to keep parts aligned and reduce vibration for reliable operation. What it does:

• Serves as a mounting/support plate that fastens appliance components in place
• Helps keep moving parts aligned to prevent rattling or misalignment
• Restores secure attachment when a worn or damaged plate causes loose panels or parts
• Commonly used where a flat bracket or support is required inside the appliance

• Disconnect power (unplug appliance or shut off circuit breaker) before starting any repair
• Remove surrounding panels as needed to access the mounting location; keep hardware for reuse unless damaged
• Reuse original screws if in good condition; replace stripped or damaged fasteners

Support plate that secures the burner tube assembly in your range. Replace if cracked, warped, or corroded to properly mount and stabilize burner components.

Mounting plate for electric and gas ranges. Secures components in place. Replace if cracked, bent, or broken to restore proper structural support.

This channel burner support is a stamped support bracket designed to hold and align the range burner channel and related components so burners sit correctly. It helps restore proper fit and stable burner operation. What it does:

• Secures the burner channel and keeps burners aligned for consistent heating
• Prevents wobbling or misalignment of the burner assembly during use
• Helps maintain correct spacing between burner components and gas valve/manifold
• Commonly replaced when the original support is bent, cracked, or damaged

• One channel burner support bracket

• Designed to mount with existing fasteners; inspect screws or clips and replace if worn
• Turn off power and gas supply (for gas ranges) before servicing; follow appliance safety procedures
• Handle sharp edges carefully; wear gloves to avoid cuts