Kenmore / Sears Range / Cooktop / Oven Switch

This is a black rocker switch used to control a function on compatible ranges/cooktops. Replacing a worn or inoperative switch restores positive on/off control and reliable operation of the connected feature.

• Controls an appliance function (such as a light or igniter circuit) with a single on/off action
• Common failure signs: switch won't stay on, no response when toggled, intermittent operation, or physical damage/discoloration
• Direct-fit replacement designed for the original switch location
• Helps restore safe, predictable control to the appliance

• Disconnect power and, if applicable, shut off gas before servicing
• Access is typically from the control panel; retain orientation of wires and note terminal positions
• Transfer wires one at a time to the new switch to avoid miswiring
• Inspect connectors for heat damage; replace damaged terminals before reassembly

This wiring harness routes power and signals between the appliance's control and various electrical components, restoring reliable electrical connections and helping the appliance operate as designed. Use it when wiring is damaged, corroded, or intermittent. What it does:

• Delivers power and signal paths between control boards, switches, and motors
• Restores lost or intermittent electrical connections that can cause failure to start or run
• Replaces burned, frayed, or broken wires and damaged connector terminals
• Helps eliminate arcing, shorts, and communication errors caused by faulty wiring

• Always disconnect all power (unplug or shut off breaker) before starting repairs
• Match connectors and wire routing to the original harness; avoid stretching or pinching wires
• Inspect mating connectors and terminals for damage before installation; replace any damaged parts
• If connectors are tight or corroded, clean or replace them rather than forcing connections

If your range burner won't heat, stays on high, or won't turn off, the infinite switch may be faulty. This part controls surface element temperature.

If your range burner won't heat, stays on high, or cycles incorrectly, the infinite switch likely failed. This direct-fit part restores precise heat control.

Fix range display issues, unresponsive controls, or error codes with this control board assembly. Common repair for ranges that won't start or heat properly.

Burner won't heat or stays on high? This infinite switch controls surface element temperature. Common fix for heat control issues on electric ranges.

Fix burners that won't light with this range igniter switch wiring harness. Restores spark ignition when push-to-turn knobs fail to ignite gas burners.

If your range burner won't heat, stays on high, or won't turn off, replace the infinite switch. This common repair takes 15-30 minutes with basic tools.

If your range burner won't heat, stays on constantly, or won't adjust temperature, the infinite switch likely failed. This part regulates heat levels.

Range burner won't heat or stays on high? This infinite switch controls surface element temperature settings. Moderate DIY repair in 30-45 minutes.

Fix burners that won't ignite with this cooktop igniter switch wiring harness. Restores spark ignition when clicks are heard but no flame appears.