Kenmore / Sears Wall Oven Manual, Care Guide

This wiring label is a replacement adhesive diagram that shows the appliance's electrical wiring layout for reference during service or repairs. It restores a clear, legible wiring diagram where the original label is worn or missing. What it does:

• Displays the appliance's wiring diagram and component connections for troubleshooting and verification.
• Helps technicians confirm correct wire routing and terminal identification during repairs.
• Replaces faded, torn, or illegible factory wiring labels that can hinder safe servicing.
• Reduces guesswork when inspecting or reassembling electrical components.

• Always disconnect power to the appliance before accessing electrical areas.
• Clean and dry the mounting surface; align the label carefully, then press firmly to adhere.
• Do not place over moving parts or vents; avoid contact with live terminals.
• If wiring appears different than the diagram, stop and verify model-specific documentation.

This wiring label is a self-adhesive diagram that identifies wire colors, terminal connections and circuit routing to help technicians and owners correctly reference electrical wiring during diagnosis or repair. It protects against miswiring and simplifies troubleshooting. What it does:

• Shows wire color codes, connector locations and hookup paths for the appliance's electrical components
• Helps prevent incorrect connections during service and reduces diagnostic time
• Makes it easier to confirm proper wiring after component replacement
• Useful when original markings have worn, been removed, or become hard to read

• Disconnect power to the appliance before inspecting or replacing the label
• Clean and dry the application surface; press label firmly to ensure full adhesion
• Place where it is visible and protected from heat, moisture, and abrasion

This is a replacement wiring label that restores the appliance's internal wiring diagram and identification markings so technicians can quickly read wiring routes and connector IDs during diagnosis or repair. What it does:

• Shows the appliance's wiring diagram, wire colors, and connector/terminal identifications
• Helps technicians locate and verify electrical connections during troubleshooting
• Prevents confusion when replacing harnesses or components after repairs
• Useful when the original label is missing, torn, or illegible

• Clean and dry the mounting surface before applying the adhesive label for best adhesion
• Align the label carefully; adhesive backing is permanent once placed
• Always unplug the appliance or disconnect power before servicing electrical components
• This label is informational; follow service manual and safety procedures when working on electrical systems

This wiring diagram is the original OEM schematic sheet that shows the appliance's electrical circuits in plain terms to help identify component connections and trace power paths for troubleshooting. What it does:

• Shows wire colors, connector locations and circuit routing so you can locate and identify electrical components.
• Helps diagnose symptoms like intermittent power, no power to controls, blown fuses or tripped breakers by tracing the affected circuit.
• Clarifies control board, motor, heater and sensor wiring relationships to reduce guesswork during repairs.
• Useful when replacing harnesses or verifying proper reassembly after service.

• One wiring diagram (schematic sheet) as shipped by the manufacturer.

• Always disconnect power to the appliance before inspecting or using the diagram to work on electrical components.
• This is a reference document only; follow all safety procedures and manufacturer service instructions when repairing.
• Handle the sheet carefully—store with the appliance model paperwork for future troubleshooting or use.