Kenmore / Sears Wall Oven Wire, Harness, Power Cord

Replacement power cord for gas ranges. Connects your unit to the wall outlet. Replace if cord is worn, cut, heat-damaged, or causing burning smells.

Supplies electrical power from wall outlet to refrigerator. Replace this cord if cut, frayed, overheated, or damaged to restore safe electrical connection.

This power cord connects your appliance to household electricity, supplying safe, reliable power to its controls and components. Replace a damaged or overheated cord to restore dependable operation and reduce the risk of shorts.

• Supplies AC power from the wall outlet to the appliance's electrical system
• Helps resolve no power, intermittent power loss, or tripped breaker issues
• Replace if the cord is cut, frayed, melted, discolored, or feels hot at the plug
• Restores safe operation when the original plug or insulation is damaged

• Disconnect power at the outlet or circuit breaker before servicing
• Note wire routing and connection points; match the original orientation for hot, neutral, and ground
• Seat the cord properly and secure with the model's required strain relief or clamp to prevent tension on terminals
• Ensure the cord is not pinched and is clear of sharp edges, hot surfaces, and moving parts; test for proper operation

Replace a damaged, frayed, or worn power cord on your gas range. This 18-gauge supply cord assembly with push-tie strain relief restores safe electrical connection.

Replacement power cord for ovens and ranges. Installs at the rear panel to restore electrical connection. Needed when original cord is frayed or damaged.

A replacement power cord kit that restores the electrical connection for a freestanding range or wall oven, letting the appliance receive mains power safely and reliably. What it does:

• Provides the main AC connection between your appliance and household power
• Replaces damaged, frayed, or burned cords that cause loss of power or intermittent operation
• Helps prevent arcing or poor contact from worn wiring or terminals
• Used when plug, cord insulation, or strain-relief components are defective

• Disconnect appliance from power at the breaker before beginning work
• Inspect terminal block and wire connections; tighten to manufacturer torque if specified
• Route cord and secure strain relief per appliance cabinet opening to avoid pinching

Replace a cracked, frayed, or missing 3-wire power cord for your electric range. This 4-foot, 40-amp cord restores safe electrical connection.

Replace your damaged or worn 6-foot range power cord. Restores safe electrical connection when the existing cord shows wear, fraying, or damage.

This is a spark ignition switch with an attached wire harness that connects to the ignition system on a gas range or wall oven. It sends an electrical signal to the spark module to ignite the gas burner when the control knob is turned. Replace this assembly if burners fail to ignite, spark intermittently, or if the wiring is damaged or burned.

This harness assembly is the appliance wiring connector bundle that carries power and signals between controls and components, restoring proper electrical connections for normal operation. What it does:

• Routes power and control signals between the control board and key components
• Replaces damaged, burned, or loose wiring that can cause intermittent operation
• Helps resolve symptoms like unresponsive controls, failure to start, or component loss of power
• Restores factory wiring layout and connector fit for reliable connections

• Disconnect power before starting; confirm power is off at the breaker
• Compare connectors and wire colors to the old harness before removal
• Route and secure harness to avoid heat or pinch points; use existing clips/mounts

Wiring harness for wall ovens. Connects electrical components inside the oven cavity. Replace if wires are frayed, burned, or connections are loose.

Replace your wall oven's internal wiring harness if damaged, frayed, or burnt. Connects electrical components to restore safe power distribution.

Wiring harness for ovens and ranges. Connects electrical components inside the appliance. Replace if wires are frayed, damaged, or connections worn.

Wiring harness for wall ovens. Connects electrical components inside the oven cavity. Replace if wires are damaged, corroded, melted, or connectors broken.