This door-mounted assembly stores detergent and rinse aid and releases them at the proper time in the wash cycle. Replace a cracked or non-dispensing unit to restore consistent detergent release and overall wash performance. What it does:
- Holds detergent and rinse aid within the inner door
- Releases detergent during the main wash cycle
- Meters rinse aid during the final rinse
- Helps prevent leaks at the dispenser opening
- Common symptoms: detergent left in cup, rinse aid not dispensing, dispenser door won't open, leaks or visible cracks
What's included:
Install notes:
- Disconnect power and shut off water supply before servicing
- Remove inner door panel to access and replace the dispenser
- Transfer any reusable seal or hardware from the original part
- After installation, run a short cycle and check for leaks around the dispenser
This part fixes the following symptoms
-
Will not dispense detergent
See more...
Do-It-Yourself Stories from Customers like You
Ne error code dirty silverware in upper third rack and door broken off soap dispenser. Nathan M. • St. George , UT • July 27, 2019
I ordered a new vario motor and a soap dispenser. I turned off the water and the breaker, disconnected the water line and the power at the front base of the unit, disconnected the drain hose from the garbage dispenser, and pulled out the dishwasher and laid it on a blanket on its face. I unscrewed and removed the plainly visible vario motor on the bottom of the machine and removed the cam from the shaft. I then used a needle nose plier to carefully turn the D-shaft on the new motor to exactly...
Read more