Lg Dishwasher Parts

Secures the dishwasher door to the cabinet and provides a stable pivot point. Replace if your bracket is cracked, broken, or missing to restore alignment.

Front cover assembly for dishwasher door. Installs on exterior door panel. Replace if cracked, damaged, discolored, or missing for restored appearance.

Dishwasher hinge bracket that secures the door hinge assembly to the appliance frame. Replace if the bracket is bent, cracked, or broken from wear.

Secures internal dishwasher components to reduce movement and noise. Replace if broken or missing to restore proper alignment. Verify fit with your model.

This assembly includes the leveling leg adjuster components used to properly level and secure the dishwasher within its cabinet opening. It allows you to raise or lower the appliance so the door aligns correctly and the unit sits stable on uneven floors. Replace this kit if the dishwasher rocks, tilts, or if the existing leveling legs are stripped, broken, or no longer hold their position.

Fix a broken or cracked dishwasher door handle. This handle restores secure door operation and clean appearance. Simple DIY repair with basic tools.

This water guide directs water through the dispenser/ice path so water flows where it should, helping prevent leaks and misdirected dispensing. It's a small molded channel designed to route cold water inside the refrigerator. What it does:

• Guides and channels water from the supply toward the dispenser or ice-making area
• Helps prevent water from dripping into areas it shouldn't and causing puddles
• Supports consistent dispensing by keeping the water path aligned
• Commonly replaced when cracked, warped, or when water is leaking or pooling

• One water guide piece as shown

• Disconnect power and shut off the water supply before replacing
• Remove any interior shelves or panels as needed to access the guide
• Handle carefully to avoid damaging mounting tabs or adjacent seals
• Secure all clips; test dispenser and check for leaks after installation

This is a mesh filter assembly that fits inside the dishwasher's sump area to catch food particles and debris during the wash cycle. It prevents large particles from recirculating onto dishes or clogging the drain pump. Replace this filter if your dishes come out dirty, if you notice food residue remaining after a cycle, or if the dishwasher is draining slowly.

Protective cover cap for dishwasher guide rail. Replaces cracked, broken, or missing covers that expose internal components. Direct fit replacement.

Replace your dishwasher's front cover assembly panel if it's cracked, discolored, or damaged. This trim piece installs on the exterior door for a clean finish.

Cap cover for dishwasher assembly. Installs to protect internal components. Replace if cracked, broken, or missing to restore proper coverage.

Replacement nameplate for your dishwasher. This faceplate label attaches to the front control panel. Replace if cracked, faded, peeling, or missing.

Dishwasher dishrack tine holder secures individual tines to the rack assembly. Replace if cracked, broken, or missing to properly hold dishes in place.

Replacement dishrack guide assembly for your dishwasher. Installs on the track system to help the rack glide smoothly. Order if cracked, broken, or missing.

Replace a cracked, broken, or missing dishwasher control panel button. This part installs on the control panel to restore cosmetic appearance and operation.

Dishes not getting clean or water not spraying? The pump casing assembly houses the circulation pump and directs water flow during wash and rinse cycles.