Lg Washer Agitator Parts

The Pulsator Assembly is an OEM replacement part for LG washing machines. It generates the agitation and pulsating motion that effectively cleans clothes during the wash cycle. This pulsator measures approximately 18 x 18 x 2.5 inches. 

Symptoms of a faulty pulsator assembly can include:

• Inadequate or inefficient washing performance
• Excessive noise or vibrations during the wash cycle
• Clothes becoming tangled or not properly agitated
• Error codes or indicators related to the pulsator or agitation system

Causes of a bad pulsator assembly include wear and tear over time, damage from foreign objects entering the wash tub, or issues with other components that impact the pulsator's operation.

This OEM LG part is also compatible with Sears/Kenmore models.

The Pulsator Cap is an OEM part for LG washing machines. It is designed to secure the pulsator (or agitator) in place, ensuring proper movement of the wash plate during the wash cycle. This component helps in the effective distribution of water and detergent, promoting thorough cleaning of clothes.

You should replace this pulsator cap if it becomes damaged, lost, or worn out. Causes of a bad pulsator cap can include regular wear and tear, exposure to heavy loads, or damage from improper handling. A compromised cap can lead to inefficient washing and potential damage to the pulsator.

Symptoms of a bad Pulsator Cap include:

• The pulsator becoming loose or dislodged
• Unusual noises during the wash cycle
• Clothes not being cleaned properly
• The washer experiencing imbalance issues

This OEM LG part is also compatible with Sears/Kenmore models.

This pulsator assembly is the wash plate at the bottom of the tub in select top-load washers. It circulates water and clothes during the wash cycle, so replacing a worn or cracked pulsator restores proper agitation and cleaning performance.

• Creates the wash action by oscillating to move water and fabrics
• Helps maintain even turnover for effective cleaning
• Common symptoms of failure: little or no agitation, poor cleaning results
• Other signs: grinding/knocking during wash, a wobbling/loose wash plate, or visible cracks/stripped center

• Disconnect power and turn off water supplies before servicing
• Remove the center cap and mounting bolt, then lift the old wash plate straight up
• Clean the hub splines; align and press the new pulsator fully onto the hub
• Reinstall the mounting bolt and cap; tighten securely and run a quick test cycle