Parts for Kenmore 791.783889 (791783889, 791 783889): Light And Splasher Parts

This part has been discontinued by the manufacturer and is no longer available.

This part has been discontinued by the manufacturer and is no longer available.

Left-side support plate for upper oven cavity. Mounts inside range to provide structural stability. Replace if cracked, warped, or damaged during service.

Right-side support plate for upper oven cavity. Replace if cracked, bent, or missing to restore structural integrity and proper oven alignment.

Decorative bezel ring that fits around your range's burner control knob. Replace if cracked, discolored, or missing to restore a clean appearance.

This part has been discontinued by the manufacturer and is no longer available.

This upper burner retainer secures the surface burner head and helps keep the burner aligned for even flame distribution and reliable ignition. It's a small replacement part that restores proper burner positioning. What it does:

• Holds the upper surface burner head in place on gas cooktops and ranges
• Keeps the burner aligned so the flame and heat pattern are consistent
• Helps prevent burner wobble that can cause ignition issues or uneven cooking
• Compatible with original mounting points and hardware on compatible Frigidaire ranges

• One retainer — burner upper

• Disconnect gas supply and power to the appliance before working on burners; follow appliance manufacturer safety instructions
• Remove burner cap and head, replace the retainer, then reassemble in the original order
• Check burner alignment and ignition after reassembly; if you smell gas or see irregular flame, stop and inspect

This adhesive identification label replaces a torn, faded or missing appliance sticker so model, serial or safety information is legible again. It helps you confirm appliance details for service, parts or safety checks. What it does:

• Restores readable model/serial and specification information that is printed on the original sticker
• Replaces damaged or faded identification and safety labels
• Makes it easier to verify the correct part or service information before repair
• Helps meet safety and inspection needs by restoring visible manufacturer info

• One adhesive identification label

• Clean and dry the mounting area before applying to ensure good adhesion
• Peel backing and press label firmly; hold for several seconds to set
• Avoid placing on textured or insulated foam surfaces where adhesion may be poor

This part has been discontinued by the manufacturer and is no longer available.

This part has been discontinued by the manufacturer and is no longer available.

This part has been discontinued by the manufacturer and is no longer available.

This light box is the interior lamp housing that secures the refrigerator light and helps direct illumination inside the compartment for better visibility. It replaces cracked, broken or yellowed housings to restore safe mounting for the lamp. What it does:

• Holds and protects the interior light socket and bulb assembly
• Directs and diffuses light for even interior illumination
• Prevents loose or exposed wiring near the lamp area
• Addresses symptoms like a cracked or missing housing, rattling near the light, or reduced/diffuse lighting due to a damaged cover

• Disconnect power to the appliance before starting any work
• Usually removes with a screwdriver or by releasing plastic tabs—keep track of fasteners
• Avoid touching the bulb with bare hands; replace bulb if damaged

Replace your gas range's damaged or missing oven front cover. This cosmetic panel installs on the front of the oven cavity to restore appearance.

Rubber bumper that cushions the range door or drawer when closing. Replace if cracked, worn, or missing to prevent rattling and protect surfaces.

Secures the oven bottom panel in place. Replace if screw is stripped, missing, or no longer holds the panel securely. Sold individually.