Parts for Ge CTD90DP2N4S1: Lower Door Parts

Replace a cracked, damaged, or worn oven door liner assembly. This inner door panel installs on the oven door and protects internal components.

This door insulation retainer is a small plastic clip that secures insulation inside a refrigerator/freezer door to help maintain proper temperature and reduce noise. It replaces worn or missing retainers to keep the door liner insulation in place. What it does:

• Secures the door insulation to the inner door liner so insulation stays positioned
• Helps prevent insulation from shifting or sagging that can affect door seal performance
• Commonly used when insulation falls out or the liner shows gaps around the insulation
• Works as a direct-fit replacement for the original retainer designed for the door assembly

• One door insulation retainer clip

• Installation generally requires removing the door panel or liner; keep track of fasteners and trim
• Handle the door liner and insulation carefully to avoid damage or tearing the insulation
• Use proper tools and disconnect power if working near electrical components or lights
• Replace all affected clips for an even, secure fit

Secures cabinet liner and interior trim panels in wall ovens. Replace if cracked or loose to restore proper alignment and prevent gaps. Confirm fit with your model.

This lower outer door (stainless) is the exterior lower front panel that restores the dryer's appearance and helps the door close properly. It replaces a dented, scratched, or damaged lower door panel for a clean, finished look. What it does:

• Replaces a damaged or dented lower outer door panel to restore the dryer's exterior finish
• Helps maintain correct door alignment and closure by providing the proper outer surface
• Prevents sharp edges or gaps that can catch clothing or cause rattling
• Improves the appliance's appearance after impact or corrosion-related damage

• Disconnect power to the appliance before starting any repair
• Support or prop the door/assembly while removing fasteners to prevent drops or pinching
• Removal/installation typically requires basic hand tools; mounting clips or screws may be reused

Spacer that fits behind oven door handles to ensure proper alignment and fit. Replace if cracked, missing, or worn to restore a snug, finished appearance.

Covers fastener holes in your oven's inner door liner for a clean finish. Replace when missing, loose, or damaged to keep grease out. Confirm fit with your model.

Replace your wall oven's door window pack assembly if the glass is cracked, broken, or scratched. Installs in the door frame for safe viewing while cooking.

ST10-16 X 7/16"

Black. 8-18 AB HXW 3/8

This set screw secures refrigerator components—most commonly door handles—to their mounting studs. Replacing a missing or stripped screw restores a solid, secure feel and helps prevent loose or wobbly handles.

• Locks the handle to its mounting stud to keep it tight and secure
• Helps resolve a loose, wobbly, sliding, or rattling handle
• Replaces a missing, rounded, or damaged set screw
• Helps maintain proper handle alignment and consistent door operation

• Unplug the appliance or switch off power before servicing
• Ensure the handle is fully seated on the studs before tightening
• Start the screw by hand to avoid cross-threading; then tighten until snug
• Do not overtighten to prevent stripping the screw or handle threads

10-32 machine screw secures panels, brackets, door hinges, and handles in ovens and ranges. Replace missing, stripped, or broken screws for tight fit.