Magic Chef Gasket & Seal

This sink flange seal is a rubber gasket that creates a watertight seal between the sink and drain flange to help prevent leaks and water damage. Use it when the flange seal is cracked, flattened, or leaking. What it does:

• Seals the gap between the sink and drain flange to stop water from leaking under the sink.
• Helps prevent sink-edge water pooling and slow drainage caused by a failed seal.
• Reduces chance of odors from trapped water beneath the flange by restoring a tight seal.
• Restores proper fit when replacing a corroded or worn sink flange assembly.

• One sink flange seal (rubber)

• Turn off water supply and disconnect drain components before replacing the seal.
• Remove the drain flange assembly, clean mating surfaces, then seat the new seal evenly.
• Avoid stretching or cutting the seal; replace it if damaged or misshapen.

This evaporator cove seal is the replacement gasket that helps keep the evaporator compartment sealed for efficient cooling and proper defrost drainage. It restores the evaporator cove barrier to help maintain temperature consistency. What it does:

• Seals the evaporator cove to limit air exchange between the evaporator area and the fresh food/freezer compartments
• Helps direct defrost water to the drain path and reduce water pooling inside the appliance
• Reduces frost buildup and cold-air loss around the evaporator area
• Commonly replaced when you see frost/ice buildup, interior water leaks, or uneven cooling

• Disconnect power before starting any repair to avoid shock or injury
• Remove shelves/food and allow the appliance to defrost if ice is present before replacing the seal
• Inspect the evaporator cover and mating surfaces; clean and dry surfaces for a proper seal
• Seat the seal evenly around the cove; avoid overstretching or sharp tools that could damage the gasket

This factory replacement sealant tube provides a flexible bond for sealing seams, joints and trim during appliance repairs. It helps restore proper sealing to reduce water seepage and protect internal components from moisture. What it does

• Creates a flexible, durable seal on seams, panels and components to help stop leaks
• Helps secure trim and retainers where gaps or separation allow moisture entry
• Reduces risk of corrosion and water damage by restoring the original seal
• Useful when replacing tubs, panels or assemblies that require a bead of sealant

• Clean and dry all surfaces before applying; remove old sealant and oils for best adhesion
• Apply an even bead and tool smooth as recommended; allow full cure time before restoring use
• Use gloves and eye protection; ensure good ventilation and avoid inhaling fumes
• Do not apply to energized components; follow for specific instructions

This O-ring creates a watertight seal in your dishwasher's wash or drain system, helping prevent leaks and maintain proper water pressure. Replace a brittle, flattened, or damaged ring to restore a reliable, leak-free connection.

• Provides a watertight seal between mating parts such as pump housings, fittings, or hose joints
• Helps stop drips and seepage caused by a worn or deformed seal
• Common symptoms: water under the unit, moisture around pump/tubing connections, or leaks after reassembly
• Replace if the old ring is cracked, cut, flattened, or hardened

• Disconnect power and turn off the water supply before servicing
• Place a towel or shallow pan to catch residual water
• Clean the groove and mating surfaces; lightly moisten or use a manufacturer-approved lubricant to help the ring seat without pinching
• Seat evenly, reassemble without overtightening, and run a short test cycle to check for leaks