Magic Chef Hose Or Tube

Made by Whirlpool. This kit includes 15 feet of copper tubing, saddle valve, teflon tape, and tubing connector. Use this kit to connect your refrigerator ice maker to water supply (usually your water shut off valve under the kitchen sink).

This drain hose routes and removes wastewater from the appliance so it can pump out normally and avoid standing water. It's a direct-fit service part used to restore proper draining. What it does

• Carries wastewater from the appliance pump to the household drain or air gap
• Restores normal draining when original hose is cracked, split, or leaking
• Helps prevent water backing up into the appliance when properly routed and secured
• Can stop intermittent leaks or reduced drain performance caused by hose damage

• One drain hose

• Disconnect power and turn off water supply before starting any repair
• Inspect hose routing and replace with the same path to avoid kinks or high loops that trap water
• Secure hose connections with appropriate clamps; tighten but avoid over-torquing
• After installation, run a short drain cycle and check all connections for leaks

This collector hose assembly routes and channels water inside the appliance to the drain area, helping maintain proper water flow during cycles. It replaces worn, cracked, or leaking collector hoses to reduce leaks and maintain performance. What it does:

• Channels wastewater from internal tub components to the drain system
• Helps prevent leaks caused by cracked, split, or brittle hose sections
• Restores proper routing when the original hose is kinked, collapsed, or damaged
• Compatible with factory routing and mounting points for correct fit

• Disconnect power and water supply before starting any repair
• Inspect adjoining clamps and fittings; replace if corroded or damaged
• Follow OEM routing and secure with the original clamps or new OEM-style clamps

This waterline assembly supplies water from the household line to the refrigerator's ice maker and/or water dispenser, restoring reliable water flow and preventing leaks from damaged tubing. Ideal when the fridge isn't filling or water is leaking. What it does

• Carries water from the home supply to the refrigerator ice maker/water dispenser
• Replaces cracked, pinched, or leaking tubing that causes visible leaks or puddles
• Restores normal fill to the ice maker and consistent water flow to the dispenser
• Helps eliminate slow or intermittent fill issues caused by restricted or damaged lines

• One waterline assembly with attached fittings as shown

• Shut off the home water supply and unplug the refrigerator before starting
• Tighten fittings to manufacturer torque—do not overtighten plastic fittings
• Inspect existing connections and replace any damaged shutoff valves or connectors
• After installation, turn water back on and check all connections for leaks; flush line per manufacturer instructions

This replacement Tube-Feed routes fluids inside the appliance to maintain proper operation of the dispense or fill system. It restores correct fluid flow and helps prevent leaks or improper dispensing when the original tube is damaged. What it does:

• Channels fluid between internal components so the unit can fill or dispense as designed
• Helps stop leaks and drips caused by cracked, split, or clogged tubing
• Restores reliable fluid flow when the original tube is kinked, blocked, or degraded
• Reduces symptoms like water pooling, incomplete fills, or dispenser malfunctions

• One Tube-Feed replacement

• Disconnect power and shut off water supply before starting any repair
• Inspect adjoining fittings, clamps, and seals; replace if worn or damaged
• Ensure proper seating and secure clamps to prevent leaks; avoid sharp bends or kinks