Parts for Kenmore 911.43456590 (91143456590, 911 43456590): Main Top Section Parts

Signals power or heating status on your cooktop control panel. Replace when light fails, stays on constantly, or lens is cracked to restore visibility.

Burner not heating or heating unevenly? This 6-inch surface coil element restores consistent heat to your range's small burner. Simple plug-in install.

If your burner won't heat or has stopped working, this 8-inch surface heating element restores cooktop function. Easy plug-in installation in minutes.

Replace your cracked or stained 6" porcelain drip bowl. Installs under the burner to catch spills and protect your range interior. Easy to clean.

Catches spills and crumbs under electric range burners. Replace if rusted, discolored, warped, or cracked to restore your cooktop's appearance.

Chrome drip pan installs under range burners to catch spills and splatters. Replace when rusty, discolored, or worn to restore kitchen appearance.

Burner not heating or making poor contact? A damaged terminal block disrupts power to heating elements. DIY-friendly repair, takes about 10 minutes.

Bisque

Black

Gray. Used on the white model

Replace a broken or worn maintop hinge on your range. This hinge secures and supports the cooktop surface when lifted for cleaning or service access.

Replacement mounting screw secures panels, brackets, and controls on ranges and ovens. Needed when original screws are missing, stripped, or damaged.

Package of 12

Nickel

Replacement screw for securing panels, trim, and mounting brackets on appliances. Use when original fastener is lost, stripped, or damaged.

This replacement screw fastens panels, brackets, or trim inside your appliance. Swapping in a new screw restores a tight, secure fit and helps stop rattles, looseness, or misalignment caused by missing or damaged hardware.

• Secures panels, brackets, or trim to the appliance chassis
• Helps maintain proper alignment and spacing of components
• Replaces missing, rusted, or stripped hardware
• Helps resolve loose panels/handles, vibration, or rattling noises

• Disconnect power before servicing; for gas appliances, also shut off the gas supply
• Match the screw to the original location; start threads by hand to avoid cross-threading
• Use the appropriate driver and tighten snugly without overtightening
• Inspect the mounting hole or clip for damage and address as needed before reassembly