Parts for Kenmore 911.43559590 (91143559590, 911 43559590): Main Top Section Parts

Signals power or heating status on your cooktop control panel. Replace when light fails, stays on constantly, or lens is cracked to restore visibility.

Burner not heating or heating unevenly? This 6-inch surface coil element restores consistent heat to your range's small burner. Simple plug-in install.

If your burner won't heat or has stopped working, this 8-inch surface heating element restores cooktop function. Easy plug-in installation in minutes.

Black

Chrome drip pan installs under range burners to catch spills and splatters. Replace when rusty, discolored, or worn to restore kitchen appearance.

This kit includes the electrical receptacle and wiring needed to connect a range heating element to the appliance's power supply. It provides the secure electrical connection point where the element plugs into the range. Replace this kit if your element won't heat up, shows signs of electrical arcing, or if the connection point is burned or damaged.

Bisque

Gray. Used on the white model

Black

Replace a broken or worn maintop hinge on your range. This hinge secures and supports the cooktop surface when lifted for cleaning or service access.

Replacement mounting screw secures panels, brackets, and controls on ranges and ovens. Needed when original screws are missing, stripped, or damaged.

Package of 12

Nickel

Replacement screw for securing panels, trim, and mounting brackets on appliances. Use when original fastener is lost, stripped, or damaged.

This replacement screw fastens panels, brackets, or trim inside your appliance. Swapping in a new screw restores a tight, secure fit and helps stop rattles, looseness, or misalignment caused by missing or damaged hardware.

• Secures panels, brackets, or trim to the appliance chassis
• Helps maintain proper alignment and spacing of components
• Replaces missing, rusted, or stripped hardware
• Helps resolve loose panels/handles, vibration, or rattling noises

• Disconnect power before servicing; for gas appliances, also shut off the gas supply
• Match the screw to the original location; start threads by hand to avoid cross-threading
• Use the appropriate driver and tighten snugly without overtightening
• Inspect the mounting hole or clip for damage and address as needed before reassembly