Maytag Dryer Switch

This rotary oven selector switch controls oven functions and temperature selection so the range operates reliably and you can choose the correct cooking mode. Designed to replace a worn or non-working selector control. What it does:

• Selects oven mode (bake, broil, etc.) and communicates the chosen setting to the control system
• Restores responsive control when the selector is stiff, intermittent, or fails to click into positions
• Helps eliminate incorrect oven operation or inability to change cooking modes
• Works as the user-facing control for oven function selection on compatible ranges

• Disconnect power to the appliance before attempting service to avoid shock or injury
• Access typically requires removing the control panel or console; handle glass and trim pieces carefully
• Verify alignment and detents before reassembling to ensure proper function

Replacement heater relay for Whirlpool appliances that controls power to the heating element. It restores reliable heat switching so cycles reach the correct temperature when the appliance calls for heat. What it does:

• Switches electrical power to the heating element when the control signals demand heat
• Replaces a failed relay that can cause no heat or intermittent heating
• Helps restore normal heating cycles and consistent performance
• Works with the appliance's control system to enable safe heating operation

• Disconnect power at the breaker or unplug the appliance before servicing
• Use appropriate tools and avoid bending connector terminals; secure all wiring after replacement

This switch finish guard is a trim piece that protects and conceals the control switch area, restoring a clean appearance and helping keep debris out of the switch opening. Designed to match the original equipment fit and finish. What it does:

• Covers and protects the control switch opening to prevent dirt and moisture intrusion
• Restores the appliance's factory appearance around the switch area
• Helps keep the switch stable and properly aligned in the control panel
• Useful when replacing a cracked, worn, or missing switch trim piece

• Basic snap-in or screw-in installation; verify fasteners before tightening
• Power off and unplug the appliance before attempting any panel work
• Handle trim pieces gently to avoid cracking; align tabs before seating
• If other switch components are damaged, inspect and replace as needed

This 4-position rotary encoder is the user-control input that lets the appliance detect selector knob positions so settings change reliably. It replaces a worn or faulty encoder to restore responsive cycle selection. What it does

• Converts knob rotation into electrical signals so the control board reads selected settings
• Replaces an encoder that causes intermittent or no response when turning the selector
• Helps stop erratic or incorrect cycle selection caused by a worn or damaged shaft or contacts
• Resolves clicking, jumpy, or unregistered position changes at the console

• One rotary encoder (4-position) as pictured

• Disconnect power to the appliance before starting any repair
• Access usually requires removing the control panel or console; keep track of screws and fasteners
• Handle the encoder and circuit board carefully to avoid ESD or mechanical damage
• Test selector operation after reinstalling the panel and restoring power